- 07 11月, 2005 40 次提交
-
-
由 Thomas Gleixner 提交于
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Thomas Gleixner 提交于
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Thomas Gleixner 提交于
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Thomas Gleixner 提交于
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Thomas Gleixner 提交于
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Thomas Gleixner 提交于
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Thomas Gleixner 提交于
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Thomas Gleixner 提交于
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Thomas Gleixner 提交于
-
由 Thomas Gleixner 提交于
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Thomas Gleixner 提交于
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Konstantin Baidarov 提交于
We've noticed that sometimes "MTD do_write_buffer(): software timeout" message was printed out when writing to a Fujitsu NOR flash. It turned out that this was because of a race in the timeout handling do_write_buffer(). A small timeout of (HZ / 1000) + 1 is used there, and sometimes if the timer interrupt handling takes more than one or even two jiffies (which is 1-2 ms with HZ == 1000) and that interrupt happens just after chip_ready() call, the driver bails out from a ready polling loop despite the chip has actually become ready while all those interrupts were handled. To deal with this issue, extra check for chip ready is neccessary on timeout expiration (and the checks should better be reordered). As do_write_oneword() uses the same approach, it needs to also be changed. Signed-off-by: NKonstantin Baidarov <kbaidarov@ru.mvista.com> Signed-off-by: NSergei Shtylyov <sshtylyov@ru.mvista.com> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Marian Balakowicz 提交于
The following patch adds support for the TQ Systems TQM834x Boards. Verified on TQM8349L. This is a resubmit after integrating the suggested changes. Signed-off-by: NMarian Balakowicz <m8@semihalf.com> Signed-off-by: NWolfgang Denk <wd@denx.de> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Lennert Buytenhek 提交于
Fix two compile warnings that occur because of treating two 'unsigned long's as 'void *'s. Signed-off-by: NLennert Buytenhek <buytenh@wantstofly.org> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Thomas Gleixner 提交于
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Thomas Gleixner 提交于
The assignement of a "const char *" to a "char *" variable is emitting a warning with gcc 4.0. We cannot change mtd->name to "const char *" as we have dynamic assignements of the name. So casting is the correct solution here Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Todd Poynor 提交于
Nathan Roberts noticed the nand_write_ecc index into oobbuf goes out of bounds when crossing an erase block boundary, causing incorrect OOB data to be written and corrupting memory. Reset the index to zero after re-preparing oobbuf for a new erase block. Signed-off-by: NTodd Poynor <tpoynor@mvista.com> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Vitaly Wool 提交于
In case of an odd offset, the result was shifted by 1 instead of 8 Signed-off-by: NVitaly Wool <vwool@ru.mvista.com> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Thomas Gleixner 提交于
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Thomas Gleixner 提交于
This reverts 405c829f commit.
-
由 Sean Young 提交于
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Sean Young 提交于
Signed-off-by: NSean Young <sean@mess.org> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Thomas Gleixner 提交于
While we are at it, reorder the includes and remove the silly /* TASK */ comment Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 David Vrabel 提交于
- Use map.virt instead of map.map_priv_1 since it has the correct type. - Use readw/writew instead of dereferencing an ioremap'd cookie. - Remove an unused variable. Signed-off-by: NDavid Vrabel <dvrabel@arcom.com> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Richard Purdie 提交于
The Sharp Zaurus akita and borzoi models are large page flash devices. This patch adds support for them to the sharpsl MTD NAND driver but keeps the oob layout and bad block positions compatible with the Sharp Zaurus 2.4 kernel and ROM bootloader. Signed-off-by: NRichard Purdie <rpurdie@rpsys.net> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Nicolas Pitre 提交于
Change to the extended cfi table parsing for Intel NOR flash that uses the info in the extended table to 'walk' the table rather than using hard coding for various primary extended query table version numbers. From: Jared Hulbert <jaredeh@gmail.com> Signed-off-by: NNicolas Pitre <nico@cam.org> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Artem B. Bityutskiy 提交于
Signed-off-by: NArtem B. Bityutskiy <dedekind@infradead.org> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Ben Dooks 提交于
Spotted by basprog@mail.ru Signed-off-by: NBen Dooks <ben-linux@fluff.org> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Todd Poynor 提交于
Some callers to block-layer commit_write function treat non-zero return as error, notably the loopback mount driver sometimes used in conjunction with JFFS2 on NAND flash for bad block avoidance, etc. Return zero for success as do various other commit_write functions. Signed-off-by: NTodd Poynor <tpoynor@mvista.com> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Nicolas Pitre 提交于
If they get inlined into non __xipram functions we're screwed. Signed-off-by: NNicolas Pitre <nico@cam.org> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Ben Dooks 提交于
Signed-off-by: NBen Dooks <ben@simtec.co.uk> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Ben Dooks 提交于
Added .owner initialisation to allow the tracking of the device_driver owners when built as a module Signed-off-by: NBen Dooks <ben-linux@fluff.org> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Ben Dooks 提交于
Added owner to device driver field for tracking when loaded as a module. Signed-off-by: NBen Dooks <ben@simtec.co.uk> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Ben Dooks 提交于
Added owner fields to the device_driver for tracking ownership when built as a module Signed-off-by: NBen Dooks <ben@simtec.co.uk> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Artem B. Bityutskiy 提交于
Don't assume eraseblock size is power of 2. Dataflash can have aligned eraseblock size. From: Peter Menzebach <pm-mtd@mw-itcon.de> Acked-by: NArtem B. Bityutskiy <dedekind@infradead.org> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Artem B. Bityutskiy 提交于
- assume wbuf may be of size which is not power of 2 - don't make strange assumption about not padding wbuf for DataFlash - use wbuf = DataFlash page and eraseblock >= 8 Dataflash pages From: Peter Menzebach <pm-mtd@mw-itcon.de> Acked-by: NArtem B. Bityutskiy <dedekind@infradead.org> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Kyungmin Park 提交于
Add density mask for better support of DDP chips. Signed-off-by: NKyungmin Park <kyungmin.park@samsung.com> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Kyungmin Park 提交于
Add suspend/resume Signed-off-by: NKyungmin Park <kyungmin.park@samsung.com> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Artem B. Bityutskiy 提交于
Signed-off-by: NArtem B. Bityutskiy <dedekind@infradead.org> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-
由 Artem B. Bityutskiy 提交于
Signed-off-by: NArtem B. Bityutskiy <dedekind@infradead.org> Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
-