- 25 9月, 2008 26 次提交
-
-
由 Chris Mason 提交于
2.6.18 seems to get caught in an infinite loop when cancel_rearming_delayed_workqueue is called more than once, so this switches to cancel_delayed_work, which is arguably more correct. Also, balance_dirty_pages can run into problems with 2.6.18 based kernels because it doesn't have the per-bdi dirty limits. This avoids calling balance_dirty_pages on the btree inode unless there is actually something to balance, which is a good optimization in general. Finally there's a compile fix for ordered-data.h Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Before, metadata checksumming was done by the callers of read_tree_block, which would set EXTENT_CSUM bits in the extent tree to show that a given range of pages was already checksummed and didn't need to be verified again. But, those bits could go away via try_to_releasepage, and the end result was bogus checksum failures on pages that never left the cache. The new code validates checksums when the page is read. It is a little tricky because metadata blocks can span pages and a single read may end up going via multiple bios. Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
There is now extent_map for mapping offsets in the file to disk and extent_io for state tracking, IO submission and extent_bufers. The new extent_map code shifts from [start,end] pairs to [start,len], and pushes the locking out into the caller. This allows a few performance optimizations and is easier to use. A number of extent_map usage bugs were fixed, mostly with failing to remove extent_map entries when changing the file. Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Using ilookup5 during data=ordered writeback could deadlock on I_LOCK. This saves a pointer to the inode instead. Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
It is very difficult to create a consistent snapshot of the btree when other writers may update the btree before the commit is done. This changes the snapshot creation to happen during the commit, while no other updates are possible. Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
This forces file data extents down the disk along with the metadata that references them. The current implementation is fairly simple, and just writes out all of the dirty pages in an inode before the commit. Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Christian Hesse 提交于
--Boundary-00=_CcOWHFYK4T+JwSj Content-Type: text/plain; charset="iso-8859-1" Content-Transfer-Encoding: 7bit Content-Disposition: inline Hello everybody, compiling btrfs into the kernel results in section mismatch warnings. __exit functions are called where they are not allowed to. The attached patch fixes this for me. Not sure if it is correct though. Signed-off-by: NChristian Hesse <mail@earthworm.de> -- Regards, Chris --Boundary-00=_CcOWHFYK4T+JwSj Content-Type: text/x-diff; charset="iso-8859-1"; name="btrfs-section_mismatches.patch" Content-Transfer-Encoding: 7bit Content-Disposition: attachment; filename="btrfs-section_mismatches.patch" Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
This allows us to defrag huge directories, but skip the expensive defrag case in more common usage, where it does not help as much. Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
btrfs_btree_balance_dirty is changed to pass the number of pages dirtied for more accurate dirty throttling. This lets the VM make better decisions about when to force some writeback. Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
- 11 9月, 2007 1 次提交
-
-
由 Chris Mason 提交于
Dead roots are trees left over after a crash, and they were either in the process of being removed or were waiting to be removed when the box crashed. Before, a search of the entire tree of root pointers was done on mount looking for dead roots. Now, the search is done the first time we load a root. This makes mount faster when there are a large number of snapshots, and it enables the block accounting code to properly update the block counts on the latest root as old versions of the root are reaped after a crash. Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
- 30 8月, 2007 1 次提交
-
-
由 Josef Bacik 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
- 11 8月, 2007 2 次提交
-
-
由 Josef Bacik 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
- 09 8月, 2007 2 次提交
-
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
- 08 8月, 2007 3 次提交
-
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
This adds two types of btree defrag, a run time form that tries to defrag recently allocated blocks in the btree when they are still in ram, and an ioctl that forces defrag of all btree blocks. File data blocks are not defragged yet, but this can make a huge difference in sequential btree reads. Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Before, snapshot deletion was a single atomic unit. This caused considerable lock contention and required an unbounded amount of space. Now, the drop_progress field in the root item is used to indicate how far along snapshot deletion is, and to resume where it left off. Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
- 11 7月, 2007 1 次提交
-
-
由 Zach Brown 提交于
Almost none of the files including module.h need to do so, remove them. Include sched.h in extent-tree.c to silence a warning about cond_resched() being undeclared. Signed-off-by: NZach Brown <zach.brown@oracle.com> Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
- 29 6月, 2007 1 次提交
-
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
- 26 6月, 2007 1 次提交
-
-
由 Chris Mason 提交于
The super block written during commit was not consistent with the state of the trees. This change adds an in-memory copy of the super so that we can make sure to write out consistent data during a commit. Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
- 23 6月, 2007 2 次提交
-
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-
由 Chris Mason 提交于
Signed-off-by: NChris Mason <chris.mason@oracle.com>
-