[PATCH] bttv: fix dst i2c read/write timeout failure.

Attached is a patch to bttv which fixes the following problems.

Affected cards and problems:
~~~~~~~~~~~~~~~~~~~~~~~~
o VP-1020 (200103A) Tuning problems, device detection.
o VP-1020 (DST-MOT) Errors during tuning, device detection fails in a while.
o VP-1030 (DST-CI) Tuning sometimes fails after CI commands.
o VP-2031 (DCT-CI) Tuning problems

The timeout happens before the actual timeout occured in the MCU
on the board, and hence the problems.

Changes: (bttv-i2c.diff)
~~~~~~~~~~~~~~~~~~~~~~~~
o Changed the custom wait queue to wait_event_interruptible_timeout()
      - Suggestion by Johannes Stezenbach.

o Fixed the wait queue timeout problem
      - This fixes the timeout problem on various cards.
      - This problem was visible as many
          * Cannot tune to channels, when signal levels are very low.
          * app_info does not work in some conditions for CI based cards
      - Smaller values worked good for newer cards, but the older cards
suffered, settled down to the worst case values that could happen in any
eventuality.
Signed-off-by: NManu Abraham <manu@kromtek.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

drivers/media/video/bttv-i2c.c

@@ -29,6 +29,7 @@
 #include <linux/moduleparam.h>
 #include <linux/init.h>
 #include <linux/delay.h>
+#include <linux/jiffies.h>
 #include <asm/io.h>
 
 #include "bttvp.h"
@@ -130,17 +131,14 @@ static u32 functionality(struct i2c_adapter *adap)
 static int
 bttv_i2c_wait_done(struct bttv *btv)
 {
-	DECLARE_WAITQUEUE(wait, current);
 	int rc = 0;
 
-	add_wait_queue(&btv->i2c_queue, &wait);
-	if (0 == btv->i2c_done)
-		msleep_interruptible(20);
-	remove_wait_queue(&btv->i2c_queue, &wait);
+	/* timeout */
+	if (wait_event_interruptible_timeout(btv->i2c_queue,
+		btv->i2c_done, msecs_to_jiffies(85)) == -ERESTARTSYS)
+
+	rc = -EIO;
 
-	if (0 == btv->i2c_done)
-		/* timeout */
-		rc = -EIO;
 	if (btv->i2c_done & BT848_INT_RACK)
 		rc = 1;
 	btv->i2c_done = 0;