提交 e0cf9576 编写于 作者: B Benjamin Herrenschmidt

powerpc/powernv: Fix indirect XSCOM unmangling

We need to unmangle the full address, not just the register
number, and we also need to support the real indirect bit
being set for in-kernel uses.
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
CC: <stable@vger.kernel.org> [v3.13]
上级 2f3f38e4
......@@ -71,11 +71,11 @@ static int opal_xscom_err_xlate(int64_t rc)
}
}
static u64 opal_scom_unmangle(u64 reg)
static u64 opal_scom_unmangle(u64 addr)
{
/*
* XSCOM indirect addresses have the top bit set. Additionally
* the reset of the top 3 nibbles is always 0.
* the rest of the top 3 nibbles is always 0.
*
* Because the debugfs interface uses signed offsets and shifts
* the address left by 3, we basically cannot use the top 4 bits
......@@ -86,10 +86,13 @@ static u64 opal_scom_unmangle(u64 reg)
* conversion here. To leave room for further xscom address
* expansion, we only clear out the top byte
*
* For in-kernel use, we also support the real indirect bit, so
* we test for any of the top 5 bits
*
*/
if (reg & (1ull << 59))
reg = (reg & ~(0xffull << 56)) | (1ull << 63);
return reg;
if (addr & (0x1full << 59))
addr = (addr & ~(0xffull << 56)) | (1ull << 63);
return addr;
}
static int opal_scom_read(scom_map_t map, u64 reg, u64 *value)
......@@ -98,8 +101,8 @@ static int opal_scom_read(scom_map_t map, u64 reg, u64 *value)
int64_t rc;
__be64 v;
reg = opal_scom_unmangle(reg);
rc = opal_xscom_read(m->chip, m->addr + reg, (__be64 *)__pa(&v));
reg = opal_scom_unmangle(m->addr + reg);
rc = opal_xscom_read(m->chip, reg, (__be64 *)__pa(&v));
*value = be64_to_cpu(v);
return opal_xscom_err_xlate(rc);
}
......@@ -109,8 +112,8 @@ static int opal_scom_write(scom_map_t map, u64 reg, u64 value)
struct opal_scom_map *m = map;
int64_t rc;
reg = opal_scom_unmangle(reg);
rc = opal_xscom_write(m->chip, m->addr + reg, value);
reg = opal_scom_unmangle(m->addr + reg);
rc = opal_xscom_write(m->chip, reg, value);
return opal_xscom_err_xlate(rc);
}
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册