md/raid10: fix that replacement cannot complete recovery after reassemble

During assemble, the spare marked for replacement is not checked.
conf->fullsync cannot be updated to be 1. As a result, recovery will
treat it as a clean array. All recovering sectors are skipped. Original
device is replaced with the not-recovered spare.

mdadm -C /dev/md0 -l10 -n4 -pn2 /dev/loop[0123]
mdadm /dev/md0 -a /dev/loop4
mdadm /dev/md0 --replace /dev/loop0
mdadm -S /dev/md0 # stop array during recovery

mdadm -A /dev/md0 /dev/loop[01234]

After reassemble, you can see recovery go on, but it completes
immediately. In fact, recovery is not actually processed.

To solve this problem, we just add the missing logics for replacment
spares. (In raid1.c or raid5.c, they have already been checked.)
Reported-by: NAlex Chen <alexchen@synology.com>
Reviewed-by: NAlex Wu <alexwu@synology.com>
Reviewed-by: NChung-Chiang Cheng <cccheng@synology.com>
Signed-off-by: NBingJing Chang <bingjingc@synology.com>
Signed-off-by: NShaohua Li <shli@fb.com>

drivers/md/raid10.c

@@ -3893,6 +3893,13 @@ static int raid10_run(struct mddev *mddev)
 			    disk->rdev->saved_raid_disk < 0)
 				conf->fullsync = 1;
 		}
+
+		if (disk->replacement &&
+		    !test_bit(In_sync, &disk->replacement->flags) &&
+		    disk->replacement->saved_raid_disk < 0) {
+			conf->fullsync = 1;
+		}
+
 		disk->recovery_disabled = mddev->recovery_disabled - 1;
 	}