提交 8e6f1521 编写于 作者: J John Crispin 提交者: David S. Miller

net: dsa: mediatek: add adjust link support for user ports

Manually adjust the port settings of user ports once PHY polling has
completed. This patch extends the adjust_link callback to configure the
per port PMCR register, applying the proper values polled from the PHY.
Without this patch flow control was not always getting setup properly.
Signed-off-by: NShashidhar Lakkavalli <shashidhar.lakkavalli@openmesh.com>
Signed-off-by: NMuciri Gatimu <muciri@openmesh.com>
Signed-off-by: NJohn Crispin <john@phrozen.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
上级 e718fe45
......@@ -625,6 +625,44 @@ static void mt7530_adjust_link(struct dsa_switch *ds, int port,
* all finished.
*/
mt7623_pad_clk_setup(ds);
} else {
u16 lcl_adv = 0, rmt_adv = 0;
u8 flowctrl;
u32 mcr = PMCR_USERP_LINK | PMCR_FORCE_MODE;
switch (phydev->speed) {
case SPEED_1000:
mcr |= PMCR_FORCE_SPEED_1000;
break;
case SPEED_100:
mcr |= PMCR_FORCE_SPEED_100;
break;
};
if (phydev->link)
mcr |= PMCR_FORCE_LNK;
if (phydev->duplex) {
mcr |= PMCR_FORCE_FDX;
if (phydev->pause)
rmt_adv = LPA_PAUSE_CAP;
if (phydev->asym_pause)
rmt_adv |= LPA_PAUSE_ASYM;
if (phydev->advertising & ADVERTISED_Pause)
lcl_adv |= ADVERTISE_PAUSE_CAP;
if (phydev->advertising & ADVERTISED_Asym_Pause)
lcl_adv |= ADVERTISE_PAUSE_ASYM;
flowctrl = mii_resolve_flowctrl_fdx(lcl_adv, rmt_adv);
if (flowctrl & FLOW_CTRL_TX)
mcr |= PMCR_TX_FC_EN;
if (flowctrl & FLOW_CTRL_RX)
mcr |= PMCR_RX_FC_EN;
}
mt7530_write(priv, MT7530_PMCR_P(port), mcr);
}
}
......
......@@ -151,6 +151,7 @@ enum mt7530_stp_state {
#define PMCR_TX_FC_EN BIT(5)
#define PMCR_RX_FC_EN BIT(4)
#define PMCR_FORCE_SPEED_1000 BIT(3)
#define PMCR_FORCE_SPEED_100 BIT(2)
#define PMCR_FORCE_FDX BIT(1)
#define PMCR_FORCE_LNK BIT(0)
#define PMCR_COMMON_LINK (PMCR_IFG_XMIT(1) | PMCR_MAC_MODE | \
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册