Blackfin: mark MUSB VRSEL as active high for appropriate boards

These boards all have the GPIO VRSEL hooked up as an active high.
Signed-off-by: NCliff Cai <cliff.cai@analog.com>
Signed-off-by: NMike Frysinger <vapier@gentoo.org>

arch/blackfin/mach-bf527/boards/cm_bf527.c

@@ -98,6 +98,10 @@ static struct musb_hdrc_config musb_config = {
 	.num_eps	= 8,
 	.dma_channels	= 8,
 	.gpio_vrsel	= GPIO_PF11,
+	/* Some custom boards need to be active low, just set it to "0"
+	 * if it is the case.
+	 */
+	.gpio_vrsel_active	= 1,
 };
 
 static struct musb_hdrc_platform_data musb_plat = {

arch/blackfin/mach-bf527/boards/ezbrd.c

@@ -62,6 +62,10 @@ static struct musb_hdrc_config musb_config = {
 	.num_eps	= 8,
 	.dma_channels	= 8,
 	.gpio_vrsel	= GPIO_PG13,
+	/* Some custom boards need to be active low, just set it to "0"
+	 * if it is the case.
+	 */
+	.gpio_vrsel_active	= 1,
 };
 
 static struct musb_hdrc_platform_data musb_plat = {

arch/blackfin/mach-bf527/boards/ezkit.c

@@ -102,6 +102,10 @@ static struct musb_hdrc_config musb_config = {
 	.num_eps	= 8,
 	.dma_channels	= 8,
 	.gpio_vrsel	= GPIO_PG13,
+	/* Some custom boards need to be active low, just set it to "0"
+	 * if it is the case.
+	 */
+	.gpio_vrsel_active	= 1,
 };
 
 static struct musb_hdrc_platform_data musb_plat = {

arch/blackfin/mach-bf548/boards/cm_bf548.c

@@ -498,6 +498,10 @@ static struct musb_hdrc_config musb_config = {
 	.num_eps	= 8,
 	.dma_channels	= 8,
 	.gpio_vrsel	= GPIO_PH6,
+	/* Some custom boards need to be active low, just set it to "0"
+	 * if it is the case.
+	 */
+	.gpio_vrsel_active	= 1,
 };
 
 static struct musb_hdrc_platform_data musb_plat = {

arch/blackfin/mach-bf548/boards/ezkit.c

@@ -603,6 +603,10 @@ static struct musb_hdrc_config musb_config = {
 	.num_eps	= 8,
 	.dma_channels	= 8,
 	.gpio_vrsel	= GPIO_PE7,
+	/* Some custom boards need to be active low, just set it to "0"
+	 * if it is the case.
+	 */
+	.gpio_vrsel_active	= 1,
 };
 
 static struct musb_hdrc_platform_data musb_plat = {