提交 8523c048 编写于 作者: S Sean Hefty 提交者: Roland Dreier

RDMA/cm: Revert association of an RDMA device when binding to loopback

Revert the following change from commit 6f8372b6 ("RDMA/cm: fix
loopback address support")

   The defined behavior of rdma_bind_addr is to associate an RDMA
   device with an rdma_cm_id, as long as the user specified a non-
   zero address.  (ie they weren't just trying to reserve a port)
   Currently, if the loopback address is passed to rdma_bind_addr,
   no device is associated with the rdma_cm_id.  Fix this.

It turns out that important apps such as Open MPI depend on
rdma_bind_addr() NOT associating any RDMA device when binding to a
loopback address.  Open MPI is being updated to deal with this, but at
least until a new Open MPI release is available, maintain the previous
behavior: allow rdma_bind_addr() to succeed, but do not bind to a
device.
Signed-off-by: NSean Hefty <sean.hefty@intel.com>
Acked-by: NSteve Wise <swise@opengridcomputing.com>
Signed-off-by: NRoland Dreier <rolandd@cisco.com>
上级 3c8ad49b
......@@ -2115,9 +2115,7 @@ int rdma_bind_addr(struct rdma_cm_id *id, struct sockaddr *addr)
if (ret)
goto err1;
if (cma_loopback_addr(addr)) {
ret = cma_bind_loopback(id_priv);
} else if (!cma_zero_addr(addr)) {
if (!cma_any_addr(addr)) {
ret = rdma_translate_ip(addr, &id->route.addr.dev_addr);
if (ret)
goto err1;
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册