mfd: TWL6030: USBOTG VBUS event generation on

With TWL6030-usb, VBUS SESS_VLD and SESS_END events are not generated
as expected. When these interrupts are enabled, charger VBUS detection
interrupt does not get generated. So USBOTG has to be dependent on charger
VBUS interrupts.
So added one bit for USBOTG and changed the handler to call the
USBOTG handler whenever there is a charger VBUS interrpt.

VBUS SESS_VLD and SESS_END event generation issue is under debug with
HW team. This fix might not be required once after fixing the issue.
Signed-off-by: NBalaji TK <balajitk@ti.com>
Signed-off-by: NHema HK <hemahk@ti.com>
Cc: Samuel Ortiz <sameo@linux.intel.com>
Signed-off-by: NFelipe Balbi <balbi@ti.com>

drivers/mfd/twl6030-irq.c

@@ -74,7 +74,7 @@ static int twl6030_interrupt_mapping[24] = {
 	USBOTG_INTR_OFFSET,	/* Bit 16	ID_WKUP			*/
 	USBOTG_INTR_OFFSET,	/* Bit 17	VBUS_WKUP		*/
 	USBOTG_INTR_OFFSET,	/* Bit 18	ID			*/
-	USBOTG_INTR_OFFSET,	/* Bit 19	VBUS			*/
+	USB_PRES_INTR_OFFSET,	/* Bit 19	VBUS			*/
 	CHARGER_INTR_OFFSET,	/* Bit 20	CHRG_CTRL		*/
 	CHARGER_INTR_OFFSET,	/* Bit 21	EXT_CHRG		*/
 	CHARGER_INTR_OFFSET,	/* Bit 22	INT_CHRG		*/
@@ -128,6 +128,13 @@ static int twl6030_irq_thread(void *data)
 
 		sts.bytes[3] = 0; /* Only 24 bits are valid*/
 
+		/*
+		 * Since VBUS status bit is not reliable for VBUS disconnect
+		 * use CHARGER VBUS detection status bit instead.
+		 */
+		if (sts.bytes[2] & 0x10)
+			sts.bytes[2] |= 0x08;
+
 		for (i = 0; sts.int_sts; sts.int_sts >>= 1, i++) {
 			local_irq_disable();
 			if (sts.int_sts & 0x1) {