提交 69ab8494 编写于 作者: T Thomas Gleixner

genirq: Wake up irq thread after action has been installed

The wake_up_process() of the new irq thread in __setup_irq() is too
early as the irqaction is not yet fully initialized especially
action->irq is not yet set. The interrupt thread might dereference the
wrong irq descriptor.

Move the wakeup after the action is installed and action->irq has been
set.
Reported-by: NMichael Buesch <mb@bu3sch.de>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
Tested-by: NMichael Buesch <mb@bu3sch.de>
上级 2d860ad7
......@@ -607,7 +607,6 @@ __setup_irq(unsigned int irq, struct irq_desc *desc, struct irqaction *new)
*/
get_task_struct(t);
new->thread = t;
wake_up_process(t);
}
/*
......@@ -690,6 +689,7 @@ __setup_irq(unsigned int irq, struct irq_desc *desc, struct irqaction *new)
(int)(new->flags & IRQF_TRIGGER_MASK));
}
new->irq = irq;
*old_ptr = new;
/* Reset broken irq detection when installing new handler */
......@@ -707,7 +707,13 @@ __setup_irq(unsigned int irq, struct irq_desc *desc, struct irqaction *new)
spin_unlock_irqrestore(&desc->lock, flags);
new->irq = irq;
/*
* Strictly no need to wake it up, but hung_task complains
* when no hard interrupt wakes the thread up.
*/
if (new->thread)
wake_up_process(new->thread);
register_irq_proc(irq, desc);
new->dir = NULL;
register_handler_proc(irq, new);
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册