drivers: PL011: replace UART_MIS reading with _RIS & _IMSC

The PL011 register UART_MIS is actually a bitwise AND of the
UART_RIS and the UART_MISC register.
Since the SBSA UART does not include the _MIS register, use the
two separate registers to get the same behaviour. Since we are
inside the spinlock and we read the _IMSC register only once, there
should be no race issue.
Signed-off-by: NAndre Przywara <andre.przywara@arm.com>
Tested-by: NMark Langsdorf <mlangsdo@redhat.com>
Tested-by: NNaresh Bhat <nbhat@cavium.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/tty/serial/amba-pl011.c

@@ -1322,11 +1322,13 @@ static irqreturn_t pl011_int(int irq, void *dev_id)
 	struct uart_amba_port *uap = dev_id;
 	unsigned long flags;
 	unsigned int status, pass_counter = AMBA_ISR_PASS_LIMIT;
+	u16 imsc;
 	int handled = 0;
 	unsigned int dummy_read;
 
 	spin_lock_irqsave(&uap->port.lock, flags);
-	status = readw(uap->port.membase + UART011_MIS);
+	imsc = readw(uap->port.membase + UART011_IMSC);
+	status = readw(uap->port.membase + UART011_RIS) & imsc;
 	if (status) {
 		do {
 			if (uap->vendor->cts_event_workaround) {
@@ -1361,7 +1363,7 @@ static irqreturn_t pl011_int(int irq, void *dev_id)
 			if (pass_counter-- == 0)
 				break;
 
-			status = readw(uap->port.membase + UART011_MIS);
+			status = readw(uap->port.membase + UART011_RIS) & imsc;
 		} while (status != 0);
 		handled = 1;
 	}