While assumed not to make a difference, not using the factor-2 prescaler
makes the receiver more susceptible to errors.

Specifically, there have been reports of problems with devices that
cannot generate a 115200 rate with a smaller error than 2.1% (e.g.
117647 bps). But this can also be reproduced with a low-speed RS232
tranceiver at 115200 when the input rate matches the nominal rate.

So whenever possible, enable the factor-2 prescaler and halve the
divisor in order to use settings closer to that of the previous
algorithm.

Fixes: 35714565 ("USB: serial: ch341: reimplement line-speed handling")
Cc: stable <stable@vger.kernel.org>	# 5.5
Reported-by: NJakub Nantl <jn@forever.cz>
Tested-by: NJakub Nantl <jn@forever.cz>
Reviewed-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>
Signed-off-by: NJohan Hovold <johan@kernel.org>