-
由 Ben Greear 提交于
The commit that went into 3.17: ath9k: Summarize hw state per channel context Group and set hw state (opmode, primary_sta, beacon conf) per channel context instead of whole list of vifs. This would allow each channel context to run in different mode (STA/AP). Signed-off-by: NFelix Fietkau <nbd@openwrt.org> Signed-off-by: NRajkumar Manoharan <rmanohar@qti.qualcomm.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com> broke multi-vif configuration due to not properly calculating the bssid mask. The test case that caught this was: create wlan0 and sta0-4 (6 total), not sure how much that matters. associate all 6 (works fine) disconnect 5 of them, leaving sta0 up Start trying to bring up the other 5 one at a time. It will fail, with iw events looking like this (in these logs, several sta are trying to come up, but symptom is the same with just one) The patch causing the regression made quite a few changes, but the part I think caused this particular problem was not recalculating the bssid mask when adding and removing interfaces. Re-adding those calls fixes my test case. Fix bad comment as well. Signed-off-by: NBen Greear <greearb@candelatech.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
daad1660