-
由 Tariq Toukan 提交于
Add support for the HW feature of multi-packet WQE in XDP xmit flow. The conventional TX descriptor (WQE, Work Queue Element) serves a single packet. Our HW has support for multi-packet WQE (MPWQE) in which a single descriptor serves multiple TX packets. This reduces both the PCI overhead and the CPU cycles wasted on writing them. In this patch we add support for the HW feature, which is supported starting from ConnectX-5. Performance: Tested packet rate for UDP 64Byte multi-stream over ConnectX-5 NICs. CPU: Intel(R) Xeon(R) CPU E5-2680 v3 @ 2.50GHz XDP_TX: We see a huge gain on single port ConnectX-5, and reach the 100 Mpps milestone. * Single-port HCA: Before: 70 Mpps After: 100 Mpps (+42.8%) * Dual-port HCA: Before: 51.7 Mpps After: 57.3 Mpps (+10.8%) * In both cases we tested traffic on one port and for now On Dual-port HCAs we see only small gain, we are working to overcome this bottleneck, but for the moment only with experimental firmware on dual port HCAs we can reach the wanted numbers as seen on Single-port HCAs. XDP_REDIRECT: Redirect from (A) ConnectX-5 to (B) ConnectX-5. Due to a setup limitation, (A) and (B) are on different NUMA nodes, so absolute performance numbers are not optimal. Note: Below is the transmit rate of (B), not the redirect rate of (A) which is in some cases higher. * (B) is single-port: Before: 77 Mpps After: 90 Mpps (+16.8%) * (B) is dual-port: Before: 61 Mpps After: 72 Mpps (+18%) Signed-off-by: NTariq Toukan <tariqt@mellanox.com> Signed-off-by: NSaeed Mahameed <saeedm@mellanox.com>
5e0d2eef