@@ -504,7 +504,7 @@ Fills a connected component with the given color.
:param image: Input/output 1- or 3-channel, 8-bit, or floating-point image. It is modified by the function unless the ``FLOODFILL_MASK_ONLY`` flag is set in the second variant of the function. See the details below.
:param mask: (For the second function only) Operation mask that should be a single-channel 8-bit image, 2 pixels wider and 2 pixels taller. The function uses and updates the mask, so you take responsibility of initializing the ``mask`` content. Flood-filling cannot go across non-zero pixels in the mask. For example, an edge detector output can be used as a mask to stop filling at edges. It is possible to use the same mask in multiple calls to the function to make sure the filled area does not overlap.
:param mask: Operation mask that should be a single-channel 8-bit image, 2 pixels wider and 2 pixels taller than ``image``. Since this is both an input and output parameter, you must take responsibility of initializing it. Flood-filling cannot go across non-zero pixels in the input mask. For example, an edge detector output can be used as a mask to stop filling at edges. On output, pixels in the mask corresponding to filled pixels in the image are set to 1 or to the a value specified in ``flags`` as described below. It is therefore possible to use the same mask in multiple calls to the function to make sure the filled areas do not overlap.
.. note:: Since the mask is larger than the filled image, a pixel :math:`(x, y)` in ``image`` corresponds to the pixel :math:`(x+1, y+1)` in the ``mask`` .
...
...
@@ -518,11 +518,11 @@ Fills a connected component with the given color.
:param rect: Optional output parameter set by the function to the minimum bounding rectangle of the repainted domain.
:param flags: Operation flags. Lower bits contain a connectivity value, 4 (default) or 8, used within the function. Connectivity determines which neighbors of a pixel are considered. Upper bits can be 0 or a combination of the following flags:
:param flags: Operation flags. The first 8 bits contain a connectivity value. The default value of 4 means that only the four nearest neighbor pixels (those that share an edge) are considered. A connectivity value of 8 means that the eight nearest neighbor pixels (those that share a corner) will be considered. The next 8 bits (8-16) contain a value between 1 and 255 with which to fill the ``mask`` (the default value is 1). For example, ``4 | ( 255 << 8 )`` will consider 4 nearest neighbours and fill the mask with a value of 255. The following additional options occupy higher bits and therefore may be further combined with the connectivity and mask fill values using bit-wise or (``|``):
* **FLOODFILL_FIXED_RANGE** If set, the difference between the current pixel and seed pixel is considered. Otherwise, the difference between neighbor pixels is considered (that is, the range is floating).
* **FLOODFILL_MASK_ONLY** If set, the function does not change the image ( ``newVal`` is ignored), but fills the mask. The flag can be used for the second variant only.
* **FLOODFILL_MASK_ONLY** If set, the function does not change the image ( ``newVal`` is ignored), and only fills the mask with the value specified in bits 8-16 of ``flags`` as described above. This option only make sense in function variants that have the ``mask`` parameter.
The functions ``floodFill`` fill a connected component starting from the seed point with the specified color. The connectivity is determined by the color/brightness closeness of the neighbor pixels. The pixel at
:math:`(x,y)` is considered to belong to the repainted domain if:
