- 22 1月, 2012 1 次提交
-
-
由 Carl Eugen Hoyos 提交于
Fixes ticket #934
-
- 21 1月, 2012 21 次提交
-
-
由 Reimar Döffinger 提交于
Around 50% faster. decode: 374139 -> 248852 decicycles syntax check: 236955 -> 123854 decicycles Signed-off-by: NReimar Döffinger <Reimar.Doeffinger@gmx.de>
-
由 Reimar Döffinger 提交于
Also encodes error or end marker into table. About 20% faster. decode: 466491 -> 374139 decicycles syntax check: 236955 -> 161182 decicycles Signed-off-by: NReimar Döffinger <Reimar.Doeffinger@gmx.de>
-
由 Reimar Döffinger 提交于
Signed-off-by: NReimar Döffinger <Reimar.Doeffinger@gmx.de>
-
由 Stefano Sabatini 提交于
This is consistent with the other filter descriptions.
-
由 Reimar Döffinger 提交于
Signed-off-by: NReimar Döffinger <Reimar.Doeffinger@gmx.de>
-
由 Reimar Döffinger 提交于
If specified runs "make fate" through valgrind using the given valgrind binary. Signed-off-by: NReimar Döffinger <Reimar.Doeffinger@gmx.de>
-
由 Michael Niedermayer 提交于
That way all mix levels as exported by the parser will have the same meaning. Previously the 3bit center mix level for eac3 was used to index in a 4 entry table leading to out of array reads. this change removes the table and offsets the ac3 variable by 4 so it matches the meanings for eac3 except the reserved case. The reserved case is then explicitly handled. Idea-by: NJustin Ruggles <justin.ruggles@gmail.com> Signed-off-by: NMichael Niedermayer <michaelni@gmx.at>
-
由 Ray Simard 提交于
Sometimes the scan finds nothing that qualifies for addition to the array and pos is zero after the loops. The code forces pos to 1 and the array is then processed as if it had one valid element in it, producing some amusing but not very useful results. I don't see the rationale for this. If pos is zero coming out of the loops, the only appropriate thing to do is set t->angle to zero. The attached patch does that. It's worked properly in several tests so far. Signed-off-by: NMichael Niedermayer <michaelni@gmx.at>
-
由 Michael Niedermayer 提交于
As the test is run during fate and the benchmark is useless for fate this very slightly speeds up fate. Its also consistent with the other tests. Signed-off-by: NMichael Niedermayer <michaelni@gmx.at>
-
由 Michael Niedermayer 提交于
Signed-off-by: NMichael Niedermayer <michaelni@gmx.at>
-
由 Michael Niedermayer 提交于
* qatar/master: Add a tool that uses avio to read and write, doing a plain copy of data ARM: fix build with FFT enabled and MDCT disabled lavf: force single-threaded decoding in avformat_find_stream_info avidec: migrate last of lavf from FF_ER_* to AV_EF_* avserver: fix build after the next bump. Conflicts: libavformat/Makefile libavformat/avidec.c libavformat/utils.c Merged-by: NMichael Niedermayer <michaelni@gmx.at>
-
由 Michael Niedermayer 提交于
Signed-off-by: NMichael Niedermayer <michaelni@gmx.at>
-
由 Michael Niedermayer 提交于
Signed-off-by: NMichael Niedermayer <michaelni@gmx.at>
-
由 Michael Niedermayer 提交于
This makes the code 2-3 times as fast Signed-off-by: NMichael Niedermayer <michaelni@gmx.at>
-
由 Michael Niedermayer 提交于
Signed-off-by: NMichael Niedermayer <michaelni@gmx.at>
-
由 Reimar Döffinger 提交于
Move handling of last byte outside of innermost loop. Signed-off-by: NReimar Döffinger <Reimar.Doeffinger@gmx.de>
-
由 Reimar Döffinger 提交于
Signed-off-by: NReimar Döffinger <Reimar.Doeffinger@gmx.de>
-
由 Reimar Döffinger 提交于
Signed-off-by: NReimar Döffinger <Reimar.Doeffinger@gmx.de>
-
由 Martin Storsjö 提交于
It also optionally can throttle its operation to a particular speed, to simulate realtime writing. Signed-off-by: NMartin Storsjö <martin@martin.st>
-
由 Michael Niedermayer 提交于
opt: Fix "libavutil/opt.c:811:20: warning: initialization discards ‘const’ qualifier from pointer target type [enabled by default]" Signed-off-by: NMichael Niedermayer <michaelni@gmx.at>
-
由 Felipe Contreras 提交于
Signed-off-by: NFelipe Contreras <felipe.contreras@gmail.com> Signed-off-by: NMans Rullgard <mans@mansr.com>
-
- 20 1月, 2012 18 次提交
-
-
由 Stefano Sabatini 提交于
-
由 Stefano Sabatini 提交于
The index for the binary_unit_prefixes array is expected to be positive, so avoid to use negative indexes for accessing it.
-
由 Stefano Sabatini 提交于
-
由 Stefano Sabatini 提交于
-
由 Stefano Sabatini 提交于
-
由 Janne Grunau 提交于
The H.264 decoder needs SPS and PPS for initialization during multi-threaded decoding. When probed single-threaded SPS and PPS are copied to extradata and are available for proper initialization of the decoder before the first frame is decoded.
-
由 Dustin Brody 提交于
Signed-off-by: NAnton Khirnov <anton@khirnov.net>
-
由 Anton Khirnov 提交于
-
由 Michael Niedermayer 提交于
* qatar/master: mpeg12: check for available bits to avoid an infinite loop fate: add some shorthands to run groups of tests fate: Give some tests more sensible names. cosmetics: Rename ffsink to avsink. Conflicts: avconv.c cmdutils.c cmdutils.h ffmpeg.c ffplay.c tests/fate/audio.mak tests/fate/demux.mak tests/fate/dpcm.mak tests/fate/image.mak tests/fate/lossless-audio.mak tests/fate/lossless-video.mak tests/fate/microsoft.mak tests/fate/pcm.mak tests/fate/real.mak tests/fate/screen.mak tests/fate/video.mak tests/fate/voice.mak tests/fate/wma.mak Merged-by: NMichael Niedermayer <michaelni@gmx.at>
-
由 Clément Bœsch 提交于
-
由 Nicolas George 提交于
-
由 Nicolas George 提交于
-
由 Michael Bradshaw 提交于
-
由 Carl Eugen Hoyos 提交于
Reviewed-by: Michael Bradshaw Reviewed-by: Paul B Mahol
-
由 Carl Eugen Hoyos 提交于
-
由 Carl Eugen Hoyos 提交于
-
由 Carl Eugen Hoyos 提交于
Reviewed-by: Paul B Mahol
-
由 Carl Eugen Hoyos 提交于
Suggested by Jean First.
-