- 01 3月, 2014 1 次提交
-
-
由 Dylan Reid 提交于
Later commits adding support for hda platform drivers will want to use the same defines and structures. Put them in a place reachable by both hda_intel and the new platform driver. This is a mostly a direct copy with a few whitespace and comment changes to make checkpatch happy. Signed-off-by: NDylan Reid <dgreid@chromium.org> Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
- 28 2月, 2014 3 次提交
-
-
由 David Henningsson 提交于
According to the HDA spec, we must write 1 to bit 15 on a CORBRP reset, read back 1, then write 0, then read back 0. This must be done while the DMA is not running. We accidentaly ended up writing back the 0 by using a writel instead of a writew to CORBWP. This caused occasional controller failure on Bay Trail hardware. [replaced error messages with dev_err() by tiwai] Signed-off-by: NDavid Henningsson <david.henningsson@canonical.com> Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
The beep input device is registered via input_register_device(), but this is called in snd_hda_attach_beep_device() where the sound devices aren't registered yet. This leads to the binding to non-existing object, thus results in failure. And, even if the binding worked (against the PCI object), it's still racy; the input device appears before the sound objects. For fixing this, register the input device properly at dev_register ops of the codec object it's bound with. Also, call snd_hda_detach_beep_device() at dev_disconnection so that it's detached at the right timing. As a bonus, since it's called in the codec's ops, we can get rid of the further call from the other codec drivers. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
This merges the bunch of changes over pci and usb sound drivers to convert to dev_err() and co.
-
- 27 2月, 2014 4 次提交
-
-
由 Takashi Iwai 提交于
Many HP laptops with STAC codecs have a docking station port and BIOS sets the pins for the input on the dock as a line in. Because the generic parser doesn't handle a line in pin as auto-switchable, this resulted in the manual capture source selection on these laptops. However, from the usability POV, the automatic switching is easier. This patch adds the line_in_auto_switch hint in the fixup function for these laptops. Even if no dock port is present, this should be harmless as the generic parser allows the auto-switching only in a limited situation (all three pins are located in different positions). Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Just a cleanup to follow the standard coding style. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Instead of the controller, the new codec object is assigned as a parent for the hd-audio beep input devices, just like already done for PCM and hwdep. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
- 26 2月, 2014 32 次提交
-
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. As there are too deep indirections (e.g. ep->chip->dev->dev), a few new local macros, usb_audio_err() & co, are introduced. Also, the device numbers in some messages are dropped, as they are shown in the prefix automatically. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. A couple of prints are difficult to convert with dev_err() so they are converted to pr_err() at least. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. A couple of prints are difficult to convert with dev_err() so they are converted to pr_err() at least. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Some debug prints are replaced with dev_dbg(), too. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. The debug prints are also reformatted to suit with dev_dbg(). Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Convert with dev_err() and co from snd_printk(), etc. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-