提交 cda2109a 编写于 作者: G Grygorii Strashko 提交者: Wolfram Sang

i2c: omap: query STP always when NACK is received

According to I2C specification the NACK should be handled as folowing:
"When SDA remains HIGH during this ninth clock pulse, this is defined as the Not
Acknowledge signal. The master can then gene rate either a STOP condition to
abort the transfer, or a repeated START condition to start a new transfer."
[http://www.nxp.com/documents/user_manual/UM10204.pdf]

The same is recomened by TI I2C wiki:
 http://processors.wiki.ti.com/index.php/I2C_Tips

Currently, the OMAP I2C driver interrupts I2C trunsfer in case of NACK, but
It queries Stop condition OMAP_I2C_CON_REG.STP=1 only if NACK has been received
during the last message transmitting/recieving.
This may lead to stuck Bus in "Bus Busy" until I2C IP reset (idle/enable).

Hence, fix it by querying Stop condition (STP) always when NACK is received.
Signed-off-by: NGrygorii Strashko <grygorii.strashko@ti.com>
Acked-by: NHein Tibosch <hein_tibosch@yahoo.es>
Acked-by: NFelipe Balbi <balbi@ti.com>
Signed-off-by: NWolfram Sang <wsa@the-dreams.de>
上级 869c6a3e
......@@ -615,11 +615,10 @@ static int omap_i2c_xfer_msg(struct i2c_adapter *adap,
if (dev->cmd_err & OMAP_I2C_STAT_NACK) {
if (msg->flags & I2C_M_IGNORE_NAK)
return 0;
if (stop) {
w = omap_i2c_read_reg(dev, OMAP_I2C_CON_REG);
w |= OMAP_I2C_CON_STP;
omap_i2c_write_reg(dev, OMAP_I2C_CON_REG, w);
}
w = omap_i2c_read_reg(dev, OMAP_I2C_CON_REG);
w |= OMAP_I2C_CON_STP;
omap_i2c_write_reg(dev, OMAP_I2C_CON_REG, w);
return -EREMOTEIO;
}
return -EIO;
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册