提交 9c76b878 编写于 作者: P Paul Walmsley 提交者: Tony Lindgren

i2c-omap: convert 'rev1' flag to generic 'rev' u8

i2c-omap discriminates only between "revision 1" or "greater than
revision 1."  A following patch introduces code that must also
discriminate between rev2.x, rev3.6, and rev3.12 controllers.  Support
this by storing the full revision data from the I2C_REV register, rather
than just a single bit.

The revision definitions may need to be extended for other ES levels
that aren't currently available here.  rev3.6 is what's present on the
2430SDP here (unknown ES revision); rev3.12 is used on the 3430ES2
here.
Signed-off-by: NPaul Walmsley <paul@pwsan.com>
Signed-off-by: NTony Lindgren <tony@atomide.com>
上级 3831f154
......@@ -38,6 +38,13 @@
#include <linux/clk.h>
#include <linux/io.h>
/* I2C controller revisions */
#define OMAP_I2C_REV_2 0x20
/* I2C controller revisions present on specific hardware */
#define OMAP_I2C_REV_ON_2430 0x36
#define OMAP_I2C_REV_ON_3430 0x3C
/* timeout waiting for the controller to respond */
#define OMAP_I2C_TIMEOUT (msecs_to_jiffies(1000))
......@@ -139,7 +146,7 @@ struct omap_i2c_dev {
* fifo_size==0 implies no fifo
* if set, should be trsh+1
*/
unsigned rev1:1;
u8 rev;
unsigned b_hw:1; /* bad h/w fixes */
unsigned idle:1;
u16 iestate; /* Saved interrupt register */
......@@ -209,7 +216,7 @@ static void omap_i2c_idle(struct omap_i2c_dev *dev)
dev->iestate = omap_i2c_read_reg(dev, OMAP_I2C_IE_REG);
omap_i2c_write_reg(dev, OMAP_I2C_IE_REG, 0);
if (dev->rev1) {
if (dev->rev < OMAP_I2C_REV_2) {
iv = omap_i2c_read_reg(dev, OMAP_I2C_IV_REG); /* Read clears */
} else {
omap_i2c_write_reg(dev, OMAP_I2C_STAT_REG, dev->iestate);
......@@ -231,7 +238,7 @@ static int omap_i2c_init(struct omap_i2c_dev *dev)
unsigned long timeout;
unsigned long internal_clk = 0;
if (!dev->rev1) {
if (dev->rev >= OMAP_I2C_REV_2) {
omap_i2c_write_reg(dev, OMAP_I2C_SYSC_REG, OMAP_I2C_SYSC_SRST);
/* For some reason we need to set the EN bit before the
* reset done bit gets set. */
......@@ -710,6 +717,7 @@ omap_i2c_probe(struct platform_device *pdev)
struct omap_i2c_dev *dev;
struct i2c_adapter *adap;
struct resource *mem, *irq, *ioarea;
void *isr;
int r;
u32 speed = 0;
......@@ -760,8 +768,7 @@ omap_i2c_probe(struct platform_device *pdev)
omap_i2c_unidle(dev);
if (cpu_is_omap15xx())
dev->rev1 = omap_i2c_read_reg(dev, OMAP_I2C_REV_REG) < 0x20;
dev->rev = omap_i2c_read_reg(dev, OMAP_I2C_REV_REG) & 0xff;
if (cpu_is_omap2430() || cpu_is_omap34xx()) {
u16 s;
......@@ -782,16 +789,16 @@ omap_i2c_probe(struct platform_device *pdev)
/* reset ASAP, clearing any IRQs */
omap_i2c_init(dev);
r = request_irq(dev->irq, dev->rev1 ? omap_i2c_rev1_isr : omap_i2c_isr,
0, pdev->name, dev);
isr = (dev->rev < OMAP_I2C_REV_2) ? omap_i2c_rev1_isr : omap_i2c_isr;
r = request_irq(dev->irq, isr, 0, pdev->name, dev);
if (r) {
dev_err(dev->dev, "failure requesting irq %i\n", dev->irq);
goto err_unuse_clocks;
}
r = omap_i2c_read_reg(dev, OMAP_I2C_REV_REG) & 0xff;
dev_info(dev->dev, "bus %d rev%d.%d at %d kHz\n",
pdev->id, r >> 4, r & 0xf, dev->speed);
pdev->id, dev->rev >> 4, dev->rev & 0xf, dev->speed);
omap_i2c_idle(dev);
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册