提交 51a92c0f 编写于 作者: J Jens Axboe

splice: fix offset mangling with direct splicing (sendfile)

If the output actor doesn't transfer the full amount of data, we will
increment ppos too much. Two related bugs in there:

- We need to break out and return actor() retval if it is shorted than
  what we spliced into the pipe.

- Adjust ppos only according to actor() return.

Also fix loop problem in generic_file_splice_read(), it should not keep
going when data has already been transferred.
Signed-off-by: NJens Axboe <jens.axboe@oracle.com>
上级 29ce2058
......@@ -492,7 +492,7 @@ ssize_t generic_file_splice_read(struct file *in, loff_t *ppos,
ret = 0;
spliced = 0;
while (len) {
while (len && !spliced) {
ret = __generic_file_splice_read(in, ppos, pipe, len, flags);
if (ret < 0)
......@@ -1060,15 +1060,10 @@ ssize_t splice_direct_to_actor(struct file *in, struct splice_desc *sd,
sd->flags &= ~SPLICE_F_NONBLOCK;
while (len) {
size_t read_len, max_read_len;
/*
* Do at most PIPE_BUFFERS pages worth of transfer:
*/
max_read_len = min(len, (size_t)(PIPE_BUFFERS*PAGE_SIZE));
size_t read_len;
ret = do_splice_to(in, &sd->pos, pipe, max_read_len, flags);
if (unlikely(ret < 0))
ret = do_splice_to(in, &sd->pos, pipe, len, flags);
if (unlikely(ret <= 0))
goto out_release;
read_len = ret;
......@@ -1080,26 +1075,17 @@ ssize_t splice_direct_to_actor(struct file *in, struct splice_desc *sd,
* could get stuck data in the internal pipe:
*/
ret = actor(pipe, sd);
if (unlikely(ret < 0))
if (unlikely(ret <= 0))
goto out_release;
bytes += ret;
len -= ret;
/*
* In nonblocking mode, if we got back a short read then
* that was due to either an IO error or due to the
* pagecache entry not being there. In the IO error case
* the _next_ splice attempt will produce a clean IO error
* return value (not a short read), so in both cases it's
* correct to break out of the loop here:
*/
if ((flags & SPLICE_F_NONBLOCK) && (read_len < max_read_len))
break;
if (ret < read_len)
goto out_release;
}
pipe->nrbufs = pipe->curbuf = 0;
return bytes;
out_release:
......@@ -1161,10 +1147,12 @@ long do_splice_direct(struct file *in, loff_t *ppos, struct file *out,
.pos = *ppos,
.u.file = out,
};
size_t ret;
long ret;
ret = splice_direct_to_actor(in, &sd, direct_splice_actor);
*ppos = sd.pos;
if (ret > 0)
*ppos += ret;
return ret;
}
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册