wl1271: RefClk configuration

Updated RefClk configuration based on reference sources. Apparently this
change will improve RF performance.
Signed-off-by: NJuuso Oikarinen <juuso.oikarinen@nokia.com>
Reviewed-by: NLuciano Coelho <luciano.coelho@nokia.com>
Signed-off-by: NLuciano Coelho <luciano.coelho@nokia.com>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

drivers/net/wireless/wl12xx/wl1271_boot.c

@@ -435,13 +435,29 @@ int wl1271_boot(struct wl1271 *wl)
 	int ret = 0;
 	u32 tmp, clk, pause;
 
-	if (REF_CLOCK == 0 || REF_CLOCK == 2)
-		/* ref clk: 19.2/38.4 */
+	if (REF_CLOCK == 0 || REF_CLOCK == 2 || REF_CLOCK == 4)
+		/* ref clk: 19.2/38.4/38.4-XTAL */
 		clk = 0x3;
 	else if (REF_CLOCK == 1 || REF_CLOCK == 3)
 		/* ref clk: 26/52 */
 		clk = 0x5;
 
+	if (REF_CLOCK != 0) {
+		u16 val;
+		/* Set clock type */
+		val = wl1271_top_reg_read(wl, OCP_REG_CLK_TYPE);
+		val &= FREF_CLK_TYPE_BITS;
+		val |= CLK_REQ_PRCM;
+		wl1271_top_reg_write(wl, OCP_REG_CLK_TYPE, val);
+	} else {
+		u16 val;
+		/* Set clock polarity */
+		val = wl1271_top_reg_read(wl, OCP_REG_CLK_POLARITY);
+		val &= FREF_CLK_POLARITY_BITS;
+		val |= CLK_REQ_OUTN_SEL;
+		wl1271_top_reg_write(wl, OCP_REG_CLK_POLARITY, val);
+	}
+
 	wl1271_reg_write32(wl, PLL_PARAMETERS, clk);
 
 	pause = wl1271_reg_read32(wl, PLL_PARAMETERS);

drivers/net/wireless/wl12xx/wl1271_boot.h

@@ -50,10 +50,17 @@ struct wl1271_static_data {
 #define WU_COUNTER_PAUSE_VAL 0x3FF
 #define WELP_ARM_COMMAND_VAL 0x4
 
-#define OCP_REG_POLARITY 0x0064
+#define OCP_REG_POLARITY     0x0064
+#define OCP_REG_CLK_TYPE     0x0448
+#define OCP_REG_CLK_POLARITY 0x0cb2
 
 #define CMD_MBOX_ADDRESS 0x407B4
 
 #define POLARITY_LOW BIT(1)
 
+#define FREF_CLK_TYPE_BITS     0xfffffe7f
+#define CLK_REQ_PRCM           0x100
+#define FREF_CLK_POLARITY_BITS 0xfffff8ff
+#define CLK_REQ_OUTN_SEL       0x700
+
 #endif