menu "Hardware Drivers Config"

config SOC_MAX32660
    bool
    config SOC_MAX32660
    select RT_USING_COMPONENTS_INIT
    select RT_USING_USER_MAIN
    select BSP_USING_UART
    select BSP_USING_UART1
    default y
        
config SOC_MAXIM
    bool 
    config SOC_MAXIM
    default y

menu "On-chip Peripheral Drivers"
    config BSP_USING_GPIO
        bool "Enable GPIO"
        select RT_USING_PIN
        default y

    menuconfig BSP_USING_UART
        bool "Enable UART"
        default y
        select RT_USING_SERIAL
        if BSP_USING_UART
            config BSP_USING_UART0
                bool "Enable UART0"
                default n

            config BSP_UART0_RX_USING_DMA
                bool "Enable UART0 RX DMA"
                depends on BSP_USING_UART0 && RT_SERIAL_USING_DMA
                default n   
                
            config BSP_USING_UART1
                bool "Enable UART1"
                default y

            config BSP_UART1_RX_USING_DMA
                bool "Enable UART1 RX DMA"
                depends on BSP_USING_UART1 && RT_SERIAL_USING_DMA
                default n
        endif
    config BSP_USING_SPI
        bool "Enable SPI"
        select RT_USING_SPI
        default n

        if BSP_USING_SPI
            config BSP_USING_SPI0
                bool "Enable SPI0 bus [MISO P0.4;MOSI P0.5;SCL P0.6;SS P0.7]"
                default y

            config BSP_USING_SPI1
                bool "Enable SPI1 bus [MISO P0.0;MOSI P0.1;SCL P0.2;SS P0.3]"
                default n
            if BSP_USING_SPI1
            config BSP_USING_SPI1A
                bool "Use SPI1A. [MISO P0.10;MOSI P0.11;SCL P0.12;SS P0.13]"
                default n
            endif
        endif
    config BSP_USING_ON_CHIP_FLASH
        select RT_USING_FAL
        bool "Enable on-chip FLASH"
        default n
    config BSP_USING_I2C
        bool "Enable I2C"
        select RT_USING_I2C
        default n

        if BSP_USING_I2C
            config BSP_USING_I2C0
                bool "Enable I2C0 bus [SCL P0.8; SDA P0.9]"
                default y
            
            config BSP_USING_I2C1
                bool "Enable I2C1 bus [SCL P0.2; SDA P0.3]"
                default n
        endif
            
     config BSP_USING_ONCHIP_RTC
         bool "Enable RTC"
         select RT_USING_RTC
         default n
        
endmenu


endmenu