menu "Hardware Drivers Config"

    menu "On-chip Peripheral Drivers"
        source "$BSP_DIR/../libraries/m2354/rtt_port/Kconfig"
    endmenu

    menu "On-board Peripheral Drivers"

        config BSP_USING_NULINKME
            bool "Enable UART0 for RTT Console.(uart0)"
            select BSP_USING_UART
            select BSP_USING_UART0
            default y
        config BOARD_USING_ESP8266
            bool "ESP8266 Wi-Fi module supporting(over uart4)"
            select BSP_USING_UART
            select BSP_USING_UART4
            select BSP_USING_UART4_RX_DMA
            select BSP_USING_UART4_TX_DMA
            select PKG_USING_AT_DEVICE
            select AT_DEVICE_USING_ESP8266
            select AT_DEVICE_ESP8266_INIT_ASYN
            default n

        config BOARD_USING_STORAGE_SDCARD
            bool "SDCARD supporting.(over sdh0)"
            select BSP_USING_SDH
            select BSP_USING_SDH0
            default n

        choice
            prompt "Select FS USB Ports"

            config BOARD_USING_USBD
                select BSP_USING_USBD
                bool "Enable USBD(over USB1.1)"
                help
                    Choose this option if you need USBD function mode.

            config BOARD_USING_USBH
                select BSP_USING_USBH
                bool "Enable USBH(over USB1.1)"
                help
                    Choose this option if you need USBH function mode.

            config BOARD_USING_OTG
                select BSP_USING_OTG
                bool "Enable OTG(over USB1.1)"
                help
                    Choose this option if you need OTG function mode.

            config BOARD_USING_USB_NONE
                select BSP_USING_USB_NONE
                bool "Disable USB1.1 port"
                help
                    Choose this option if you need not USB function.

        endchoice


    endmenu

    menu "Board extended module drivers"
        config BOARD_USING_SEGMENT_LCD
            bool "Segment LCD supporting.(over lcd)"
            select BSP_USING_SLCD
            default n

    endmenu

    source "$BSP_DIR/../libraries/nu_packages/Kconfig"

endmenu