e1000: init link state correctly

As reported by Andrew Lutomirski <amluto@gmail.com>

All the intel wired ethernet drivers were calling netif_carrier_off
and netif_stop_queue (or variants) before calling register_netdevice

This is incorrect behavior as was pointed out by davem, and causes
ifconfig and friends to report a strange state before first link
after the driver was loaded.

This apparently confused *some* versions of networkmanager.

Andy tested this for e1000e and confirmed it was working for him.
Signed-off-by: NJesse Brandeburg <jesse.brandeburg@intel.com>
Reported-by: NAndrew Lutomirski <amluto@gmail.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/e1000/e1000_main.c

@@ -1234,15 +1234,14 @@ static int __devinit e1000_probe(struct pci_dev *pdev,
 	    !e1000_check_mng_mode(hw))
 		e1000_get_hw_control(adapter);
 
-	/* tell the stack to leave us alone until e1000_open() is called */
-	netif_carrier_off(netdev);
-	netif_stop_queue(netdev);
-
 	strcpy(netdev->name, "eth%d");
 	err = register_netdev(netdev);
 	if (err)
 		goto err_register;
 
+	/* carrier off reporting is important to ethtool even BEFORE open */
+	netif_carrier_off(netdev);
+
 	DPRINTK(PROBE, INFO, "Intel(R) PRO/1000 Network Connection\n");
 
 	cards_found++;
@@ -1441,6 +1440,8 @@ static int e1000_open(struct net_device *netdev)
 	if (test_bit(__E1000_TESTING, &adapter->flags))
 		return -EBUSY;
 
+	netif_carrier_off(netdev);
+
 	/* allocate transmit descriptors */
 	err = e1000_setup_all_tx_resources(adapter);
 	if (err)