提交 7682455e 编写于 作者: D David S. Miller
......@@ -505,27 +505,52 @@ int i2400mu_suspend(struct usb_interface *iface, pm_message_t pm_msg)
#ifdef CONFIG_PM
struct usb_device *usb_dev = i2400mu->usb_dev;
#endif
unsigned is_autosuspend = 0;
struct i2400m *i2400m = &i2400mu->i2400m;
#ifdef CONFIG_PM
if (usb_dev->auto_pm > 0)
is_autosuspend = 1;
#endif
d_fnstart(3, dev, "(iface %p pm_msg %u)\n", iface, pm_msg.event);
if (i2400m->updown == 0)
goto no_firmware;
d_printf(1, dev, "fw up, requesting standby\n");
if (i2400m->state == I2400M_SS_DATA_PATH_CONNECTED && is_autosuspend) {
/* ugh -- the device is connected and this suspend
* request is an autosuspend one (not a system standby
* / hibernate).
*
* The only way the device can go to standby is if the
* link with the base station is in IDLE mode; that
* were the case, we'd be in status
* I2400M_SS_CONNECTED_IDLE. But we are not.
*
* If we *tell* him to go power save now, it'll reset
* as a precautionary measure, so if this is an
* autosuspend thing, say no and it'll come back
* later, when the link is IDLE
*/
result = -EBADF;
d_printf(1, dev, "fw up, link up, not-idle, autosuspend: "
"not entering powersave\n");
goto error_not_now;
}
d_printf(1, dev, "fw up: entering powersave\n");
atomic_dec(&i2400mu->do_autopm);
result = i2400m_cmd_enter_powersave(i2400m);
atomic_inc(&i2400mu->do_autopm);
#ifdef CONFIG_PM
if (result < 0 && usb_dev->auto_pm == 0) {
if (result < 0 && !is_autosuspend) {
/* System suspend, can't fail */
dev_err(dev, "failed to suspend, will reset on resume\n");
result = 0;
}
#endif
if (result < 0)
goto error_enter_powersave;
i2400mu_notification_release(i2400mu);
d_printf(1, dev, "fw up, got standby\n");
d_printf(1, dev, "powersave requested\n");
error_enter_powersave:
error_not_now:
no_firmware:
d_fnend(3, dev, "(iface %p pm_msg %u) = %d\n",
iface, pm_msg.event, result);
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册