menu "Hardware Drivers Config"

config SOC_STM32F767ZI 
    bool
    select SOC_SERIES_STM32F7
    default y

menu "Onboard Peripheral Drivers"

    config BSP_USING_USB_TO_USART 
        bool "Enable USB TO USART (uart3)"
        select BSP_USING_UART3
        default y
        
	config BSP_USING_ETH
		bool "Enable Ethernet"
		select RT_USING_LWIP
		default n

		if BSP_USING_ETH
			choice
				prompt "On-board PHY chip"
				default PHY_USING_LAN8720A

				config PHY_USING_LAN8720A
					bool "LAN8720A"

				config PHY_USING_DM9161CEP
					bool "DM9161CEP"

			endchoice
		endif
 
endmenu

menu "On-chip Peripheral Drivers"

    config BSP_USING_GPIO
        bool "Enable GPIO"
        select RT_USING_PIN
        default y

    menuconfig BSP_USING_UART
        bool "Enable UART3"
        default y
        select RT_USING_SERIAL
        if BSP_USING_UART
            config BSP_USING_UART3
                bool "Enable UART3"
                default y

            config BSP_UART3_RX_USING_DMA
                bool "Enable UART3 RX DMA"
                depends on BSP_USING_UART3 && RT_SERIAL_USING_DMA
                default n
        endif

endmenu

menu "Board extended module Drivers"

endmenu
 
endmenu