提交 a34631c2 编写于 作者: M Mark Greer 提交者: Samuel Ortiz

NFC: trf7970a: Remove support for 'vin-voltage-override' DT property

The 'vin-voltage-override' DT property is used by the trf7970a
driver to override the voltage presented to the driver by the
regulator subsystem.  This is unnecessary as properly specifying
the regulator chain via DT properties will accomplish the same
thing.  Therefore, remove support for 'vin-voltage-override'.
Signed-off-by: NMark Greer <mgreer@animalcreek.com>
Signed-off-by: NSamuel Ortiz <sameo@linux.intel.com>
上级 fcc652f6
......@@ -13,7 +13,6 @@ Optional SoC Specific Properties:
- pinctrl-names: Contains only one value - "default".
- pintctrl-0: Specifies the pin control groups used for this controller.
- autosuspend-delay: Specify autosuspend delay in milliseconds.
- vin-voltage-override: Specify voltage of VIN pin in microvolts.
- irq-status-read-quirk: Specify that the trf7970a being used has the
"IRQ Status Read" erratum.
- en2-rf-quirk: Specify that the trf7970a being used has the "EN2 RF"
......@@ -40,7 +39,6 @@ Example (for ARM-based BeagleBone with TRF7970A on SPI1):
ti,enable-gpios = <&gpio2 2 GPIO_ACTIVE_LOW>,
<&gpio2 5 GPIO_ACTIVE_LOW>;
vin-supply = <&ldo3_reg>;
vin-voltage-override = <5000000>;
vdd-io-supply = <&ldo2_reg>;
autosuspend-delay = <30000>;
irq-status-read-quirk;
......
......@@ -2005,12 +2005,6 @@ static int trf7970a_get_autosuspend_delay(struct device_node *np)
return autosuspend_delay;
}
static int trf7970a_get_vin_voltage_override(struct device_node *np,
u32 *vin_uvolts)
{
return of_property_read_u32(np, "vin-voltage-override", vin_uvolts);
}
static int trf7970a_probe(struct spi_device *spi)
{
struct device_node *np = spi->dev.of_node;
......@@ -2108,10 +2102,7 @@ static int trf7970a_probe(struct spi_device *spi)
goto err_destroy_lock;
}
ret = trf7970a_get_vin_voltage_override(np, &uvolts);
if (ret)
uvolts = regulator_get_voltage(trf->regulator);
if (uvolts > 4000000)
trf->chip_status_ctrl = TRF7970A_CHIP_STATUS_VRS5_3;
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册