# Magic Key Usage
- [When to Use](#section2350114718546)
- [How to Use](#section3305151511559)
## When to Use
When the system does not respond, you can use the magic key function to check whether the system is locked and interrupted \(the magic key also does not respond\) or view the system task running status.
If the interrupt is responded, you can use the magic key to check the CPU usage \(**cpup**\) in the task information to find out the task that occupies the CPU for a long period of time and causes other tasks in the system not to respond. \(Generally, the high-priority tasks always preempt the CPU and cause the low-priority tasks not to respond.\)
## How to Use
1. Configure macro **LOSCFG\_ENABLE\_MAGICKEY**.
The magic key depends on the **LOSCFG\_ENABLE\_MAGICKEY** macro. To use the magic key, enable the **Enable MAGIC KEY** configuration item using **menuconfig**.
Debug ---\> Enable MAGIC KEY
If this configuration item is disabled, the magic key is invalid.
> **NOTE:**
>1. In **menuconfig**, you can move the cursor to **LOSCFG\_ENABLE\_MAGICKEY** and enter a question mark \(?\) to view the help information.
2. Press **Ctrl+R** to enable the magic key detection function.
When the UART or USB-to-virtual serial port is connected, press **Ctrl+R** to enable the magic key detection function. The message "Magic key on" is displayed. After you press **Ctrl+R** again, the magic key detection function is disabled, and message "Magic key off" is displayed. The functions of the magic key are as follows:
- **Ctrl+Z**: help key, which is used to display the brief introduction to related magic keys.
- **Ctrl+T**: displays task information.
- **Ctrl+P**: The system proactively enters the panic state. After the panic-related information is printed, the system is suspended.
- **Ctrl+E**: The system checks the integrity of the memory pool. If an error is detected, the system displays an error message. If no error is detected, the system displays "system memcheck over, all passed!".
> **NOTICE:**
>When the magic key detection function is enabled and special characters need to be entered through the UART or USB-to-virtual serial port, ensure that the special characters are not the same as the magic key values. Otherwise, the magic key may be triggered by mistake, which may cause errors in the original design.