/* * INET An implementation of the TCP/IP protocol suite for the LINUX * operating system. INET is implemented using the BSD Socket * interface as the means of communication with the user level. * * Global definitions for the Ethernet IEEE 802.3 interface. * * Version: @(#)if_ether.h 1.0.1a 02/08/94 * * Author: Fred N. van Kempen, * Donald Becker, * Alan Cox, * Steve Whitehouse, * * This program is free software; you can redistribute it and/or * modify it under the terms of the GNU General Public License * as published by the Free Software Foundation; either version * 2 of the License, or (at your option) any later version. */ #ifndef _LINUX_IF_ETHER_H #define _LINUX_IF_ETHER_H #include /* * IEEE 802.3 Ethernet magic constants. The frame sizes omit the preamble * and FCS/CRC (frame check sequence). */ #define ETH_ALEN 6 /* Octets in one ethernet addr */ #define ETH_HLEN 14 /* Total octets in header. */ #define ETH_ZLEN 60 /* Min. octets in frame sans FCS */ #define ETH_DATA_LEN 1500 /* Max. octets in payload */ #define ETH_FRAME_LEN 1514 /* Max. octets in frame sans FCS */ #define ETH_FCS_LEN 4 /* Octets in the FCS */ /* * These are the defined Ethernet Protocol ID's. */ #define ETH_P_LOOP 0x0060 /* Ethernet Loopback packet */ #define ETH_P_PUP 0x0200 /* Xerox PUP packet */ #define ETH_P_PUPAT 0x0201 /* Xerox PUP Addr Trans packet */ #define ETH_P_IP 0x0800 /* Internet Protocol packet */ #define ETH_P_X25 0x0805 /* CCITT X.25 */ #define ETH_P_ARP 0x0806 /* Address Resolution packet */ #define ETH_P_BPQ 0x08FF /* G8BPQ AX.25 Ethernet Packet [ NOT AN OFFICIALLY REGISTERED ID ] */ #define ETH_P_IEEEPUP 0x0a00 /* Xerox IEEE802.3 PUP packet */ #define ETH_P_IEEEPUPAT 0x0a01 /* Xerox IEEE802.3 PUP Addr Trans packet */ #define ETH_P_DEC 0x6000 /* DEC Assigned proto */ #define ETH_P_DNA_DL 0x6001 /* DEC DNA Dump/Load */ #define ETH_P_DNA_RC 0x6002 /* DEC DNA Remote Console */ #define ETH_P_DNA_RT 0x6003 /* DEC DNA Routing */ #define ETH_P_LAT 0x6004 /* DEC LAT */ #define ETH_P_DIAG 0x6005 /* DEC Diagnostics */ #define ETH_P_CUST 0x6006 /* DEC Customer use */ #define ETH_P_SCA 0x6007 /* DEC Systems Comms Arch */ #define ETH_P_TEB 0x6558 /* Trans Ether Bridging */ #define ETH_P_RARP 0x8035 /* Reverse Addr Res packet */ #define ETH_P_ATALK 0x809B /* Appletalk DDP */ #define ETH_P_AARP 0x80F3 /* Appletalk AARP */ #define ETH_P_8021Q 0x8100 /* 802.1Q VLAN Extended Header */ #define ETH_P_IPX 0x8137 /* IPX over DIX */ #define ETH_P_IPV6 0x86DD /* IPv6 over bluebook */ #define ETH_P_PAUSE 0x8808 /* IEEE Pause frames. See 802.3 31B */ #define ETH_P_SLOW 0x8809 /* Slow Protocol. See 802.3ad 43B */ #define ETH_P_WCCP 0x883E /* Web-cache coordination protocol * defined in draft-wilson-wrec-wccp-v2-00.txt */ #define ETH_P_PPP_DISC 0x8863 /* PPPoE discovery messages */ #define ETH_P_PPP_SES 0x8864 /* PPPoE session messages */ #define ETH_P_MPLS_UC 0x8847 /* MPLS Unicast traffic */ #define ETH_P_MPLS_MC 0x8848 /* MPLS Multicast traffic */ #define ETH_P_ATMMPOA 0x884c /* MultiProtocol Over ATM */ #define ETH_P_ATMFATE 0x8884 /* Frame-based ATM Transport * over Ethernet */ #define ETH_P_PAE 0x888E /* Port Access Entity (IEEE 802.1X) */ #define ETH_P_AOE 0x88A2 /* ATA over Ethernet */ #define ETH_P_TIPC 0x88CA /* TIPC */ #define ETH_P_FCOE 0x8906 /* Fibre Channel over Ethernet */ #define ETH_P_EDSA 0xDADA /* Ethertype DSA [ NOT AN OFFICIALLY REGISTERED ID ] */ /* * Non DIX types. Won't clash for 1500 types. */ #define ETH_P_802_3 0x0001 /* Dummy type for 802.3 frames */ #define ETH_P_AX25 0x0002 /* Dummy protocol id for AX.25 */ #define ETH_P_ALL 0x0003 /* Every packet (be careful!!!) */ #define ETH_P_802_2 0x0004 /* 802.2 frames */ #define ETH_P_SNAP 0x0005 /* Internal only */ #define ETH_P_DDCMP 0x0006 /* DEC DDCMP: Internal only */ #define ETH_P_WAN_PPP 0x0007 /* Dummy type for WAN PPP frames*/ #define ETH_P_PPP_MP 0x0008 /* Dummy type for PPP MP frames */ #define ETH_P_LOCALTALK 0x0009 /* Localtalk pseudo type */ #define ETH_P_CAN 0x000C /* Controller Area Network */ #define ETH_P_PPPTALK 0x0010 /* Dummy type for Atalk over PPP*/ #define ETH_P_TR_802_2 0x0011 /* 802.2 frames */ #define ETH_P_MOBITEX 0x0015 /* Mobitex (kaz@cafe.net) */ #define ETH_P_CONTROL 0x0016 /* Card specific control frames */ #define ETH_P_IRDA 0x0017 /* Linux-IrDA */ #define ETH_P_ECONET 0x0018 /* Acorn Econet */ #define ETH_P_HDLC 0x0019 /* HDLC frames */ #define ETH_P_ARCNET 0x001A /* 1A for ArcNet :-) */ #define ETH_P_DSA 0x001B /* Distributed Switch Arch. */ #define ETH_P_TRAILER 0x001C /* Trailer switch tagging */ #define ETH_P_PHONET 0x00F5 /* Nokia Phonet frames */ #define ETH_P_IEEE802154 0x00F6 /* IEEE802.15.4 frame */ /* * This is an Ethernet frame header. */ struct ethhdr { unsigned char h_dest[ETH_ALEN]; /* destination eth addr */ unsigned char h_source[ETH_ALEN]; /* source ether addr */ __be16 h_proto; /* packet type ID field */ } __attribute__((packed)); #ifdef __KERNEL__ #include static inline struct ethhdr *eth_hdr(const struct sk_buff *skb) { return (struct ethhdr *)skb_mac_header(skb); } int eth_header_parse(const struct sk_buff *skb, unsigned char *haddr); #ifdef CONFIG_SYSCTL extern struct ctl_table ether_table[]; #endif extern ssize_t sysfs_format_mac(char *buf, const unsigned char *addr, int len); /* * Display a 6 byte device address (MAC) in a readable format. */ extern char *print_mac(char *buf, const unsigned char *addr); #define MAC_FMT "%02x:%02x:%02x:%02x:%02x:%02x" #define MAC_BUF_SIZE 18 #define DECLARE_MAC_BUF(var) char var[MAC_BUF_SIZE] __maybe_unused #endif #endif /* _LINUX_IF_ETHER_H */