x86, apic: Add probe() for apic_flat

Currently we start with the default apic_flat mode and switch to some other
apic model depending on the apic drivers acpi_madt_oem_check() routines and
later followed by the apic drivers probe() routines.

Once we selected non flat mode there was no case where we fall back to
flat mode again.

Upcoming changes allow bios-enabled x2apic mode to be disabled by the OS
if interrupt-remapping etc is not setup properly by the bios.

We now has a case for the apic to fall back to legacy flat mode during
apic driver probe() seqeuence. Add a simple flat_probe() which allows
the apic_flat mode to be the last fallback option.
Signed-off-by: NYinghai Lu <yinghai@kernel.org>
Link: http://lkml.kernel.org/r/20111222014632.484984298@sbsiddha-desk.sc.intel.comSigned-off-by: NSuresh Siddha <suresh.b.siddha@intel.com>
Signed-off-by: NH. Peter Anvin <hpa@linux.intel.com>

arch/x86/kernel/apic/apic_flat_64.c

@@ -171,9 +171,14 @@ static int flat_phys_pkg_id(int initial_apic_id, int index_msb)
 	return initial_apic_id >> index_msb;
 }
 
+static int flat_probe(void)
+{
+	return 1;
+}
+
 static struct apic apic_flat =  {
 	.name				= "flat",
-	.probe				= NULL,
+	.probe				= flat_probe,
 	.acpi_madt_oem_check		= flat_acpi_madt_oem_check,
 	.apic_id_registered		= flat_apic_id_registered,