提交 b9a9b4b0 编写于 作者: S Stephen Hemminger 提交者: David S. Miller

etherh: build fix for net-next

Fix build of ARM etherh driver with new net_device_ops.
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
上级 6976a1d6
...@@ -4,7 +4,7 @@ ...@@ -4,7 +4,7 @@
# #
obj-$(CONFIG_ARM_AM79C961A) += am79c961a.o obj-$(CONFIG_ARM_AM79C961A) += am79c961a.o
obj-$(CONFIG_ARM_ETHERH) += etherh.o obj-$(CONFIG_ARM_ETHERH) += etherh.o ../8390.o
obj-$(CONFIG_ARM_ETHER3) += ether3.o obj-$(CONFIG_ARM_ETHER3) += ether3.o
obj-$(CONFIG_ARM_ETHER1) += ether1.o obj-$(CONFIG_ARM_ETHER1) += ether1.o
obj-$(CONFIG_ARM_AT91_ETHER) += at91_ether.o obj-$(CONFIG_ARM_AT91_ETHER) += at91_ether.o
......
...@@ -637,6 +637,21 @@ static const struct ethtool_ops etherh_ethtool_ops = { ...@@ -637,6 +637,21 @@ static const struct ethtool_ops etherh_ethtool_ops = {
.get_drvinfo = etherh_get_drvinfo, .get_drvinfo = etherh_get_drvinfo,
}; };
static const struct net_device_ops etherh_netdev_ops = {
.ndo_open = etherh_open,
.ndo_stop = etherh_close,
.ndo_set_config = etherh_set_config,
.ndo_start_xmit = ei_start_xmit,
.ndo_tx_timeout = ei_tx_timeout,
.ndo_get_stats = ei_get_stats,
.ndo_set_multicast_list = ei_set_multicast_list,
.ndo_validate_addr = eth_validate_addr,
.ndo_change_mtu = eth_change_mtu,
#ifdef CONFIG_NET_POLL_CONTROLLER
.ndo_poll_controller = ei_poll,
#endif
};
static u32 etherh_regoffsets[16]; static u32 etherh_regoffsets[16];
static u32 etherm_regoffsets[16]; static u32 etherm_regoffsets[16];
...@@ -663,9 +678,7 @@ etherh_probe(struct expansion_card *ec, const struct ecard_id *id) ...@@ -663,9 +678,7 @@ etherh_probe(struct expansion_card *ec, const struct ecard_id *id)
SET_NETDEV_DEV(dev, &ec->dev); SET_NETDEV_DEV(dev, &ec->dev);
dev->open = etherh_open; dev->netdev_ops = &etherh_netdev_ops;
dev->stop = etherh_close;
dev->set_config = etherh_set_config;
dev->irq = ec->irq; dev->irq = ec->irq;
dev->ethtool_ops = &etherh_ethtool_ops; dev->ethtool_ops = &etherh_ethtool_ops;
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册