提交 9e2ef36b 编写于 作者: D Dave Olson 提交者: Roland Dreier

IB/ipath: Clean up some comments

Signed-off-by: NDave Olson <dave.olson@qlogic.com>
Signed-off-by: NRoland Dreier <rolandd@cisco.com>
上级 3029fcc3
......@@ -1050,11 +1050,6 @@ static int mmap_piobufs(struct vm_area_struct *vma,
phys = dd->ipath_physaddr + piobufs;
/*
* Don't mark this as non-cached, or we don't get the
* write combining behavior we want on the PIO buffers!
*/
#if defined(__powerpc__)
/* There isn't a generic way to specify writethrough mappings */
pgprot_val(vma->vm_page_prot) |= _PAGE_NO_CACHE;
......
......@@ -1022,7 +1022,8 @@ static int ipath_setup_ht_config(struct ipath_devdata *dd,
do {
u8 cap_type;
/* the HT capability type byte is 3 bytes after the
/*
* The HT capability type byte is 3 bytes after the
* capability byte.
*/
if (pci_read_config_byte(pdev, pos + 3, &cap_type)) {
......
......@@ -535,7 +535,7 @@ static void ipath_pe_handle_hwerrors(struct ipath_devdata *dd, char *msg,
if (hwerrs & INFINIPATH_HWE_SERDESPLLFAILED) {
/*
* If it occurs, it is left masked since the eternal
* If it occurs, it is left masked since the external
* interface is unused
*/
dd->ipath_hwerrmask &= ~INFINIPATH_HWE_SERDESPLLFAILED;
......
......@@ -128,9 +128,8 @@ int ipath_lkey_ok(struct ipath_qp *qp, struct ipath_sge *isge,
int ret;
/*
* We use LKEY == zero to mean a physical kmalloc() address.
* This is a bit of a hack since we rely on dma_map_single()
* being reversible by calling bus_to_virt().
* We use LKEY == zero for kernel virtual addresses
* (see ipath_get_dma_mr and ipath_dma.c).
*/
if (sge->lkey == 0) {
struct ipath_pd *pd = to_ipd(qp->ibqp.pd);
......
......@@ -943,7 +943,7 @@ static int ipath_verbs_send_pio(struct ipath_qp *qp, u32 *hdr, u32 hdrwords,
* ipath_verbs_send - send a packet
* @qp: the QP to send on
* @hdr: the packet header
* @hdrwords: the number of words in the header
* @hdrwords: the number of 32-bit words in the header
* @ss: the SGE to send
* @len: the length of the packet in bytes
*/
......@@ -955,7 +955,10 @@ int ipath_verbs_send(struct ipath_qp *qp, struct ipath_ib_header *hdr,
int ret;
u32 dwords = (len + 3) >> 2;
/* +1 is for the qword padding of pbc */
/*
* Calculate the send buffer trigger address.
* The +1 counts for the pbc control dword following the pbc length.
*/
plen = hdrwords + dwords + 1;
/* Drop non-VL15 packets if we are not in the active state */
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册