[SCSI] qla2xxx: Re-register FDMI information after a LIP.

Original code would (incorrectly) only re-register after a
loop-down condition.  Also, FDMI registration should be enabled
by default.
Signed-off-by: NAndrew Vasquez <andrew.vasquez@qlogic.com>
Signed-off-by: NJames Bottomley <James.Bottomley@HansenPartnership.com>

drivers/scsi/qla2xxx/qla_isr.c

@@ -409,6 +409,7 @@ qla2x00_async_event(scsi_qla_host_t *ha, uint16_t *mb)
 		}
 
 		set_bit(REGISTER_FC4_NEEDED, &ha->dpc_flags);
+		set_bit(REGISTER_FDMI_NEEDED, &ha->dpc_flags);
 
 		ha->flags.management_server_logged_in = 0;
 		qla2x00_post_aen_work(ha, FCH_EVT_LIP, mb[1]);
@@ -454,8 +455,6 @@ qla2x00_async_event(scsi_qla_host_t *ha, uint16_t *mb)
 
 		ha->flags.management_server_logged_in = 0;
 		ha->link_data_rate = PORT_SPEED_UNKNOWN;
-		if (ql2xfdmienable)
-			set_bit(REGISTER_FDMI_NEEDED, &ha->dpc_flags);
 		qla2x00_post_aen_work(ha, FCH_EVT_LINKDOWN, 0);
 		break;
 
@@ -511,6 +510,7 @@ qla2x00_async_event(scsi_qla_host_t *ha, uint16_t *mb)
 			set_bit(RESET_MARKER_NEEDED, &ha->dpc_flags);
 		}
 		set_bit(REGISTER_FC4_NEEDED, &ha->dpc_flags);
+		set_bit(REGISTER_FDMI_NEEDED, &ha->dpc_flags);
 
 		ha->flags.gpsc_supported = 1;
 		ha->flags.management_server_logged_in = 0;

drivers/scsi/qla2xxx/qla_os.c

@@ -67,7 +67,7 @@ static void qla2x00_free_device(scsi_qla_host_t *);
 
 static void qla2x00_config_dma_addressing(scsi_qla_host_t *ha);
 
-int ql2xfdmienable;
+int ql2xfdmienable=1;
 module_param(ql2xfdmienable, int, S_IRUGO|S_IRUSR);
 MODULE_PARM_DESC(ql2xfdmienable,
 		"Enables FDMI registratons "