From 7111ebc97ed53a32314011c85a6f235f0dab8ae8 Mon Sep 17 00:00:00 2001 From: Sarah Sharp Date: Tue, 14 Dec 2010 13:24:55 -0800 Subject: [PATCH] xhci: Resume bus on any port status change. The original code that resumed the USB bus on a port status change would only do so when there was a device connected to the port. If a device was just disconnected, the event would be queued for khubd, but khubd wouldn't run. That would leave the connect status change (CSC) bit set. If a USB device was plugged into that same port, the xHCI host controller would set the current connect status (CCS) bit. But since the CSC bit was already set, it would not generate an interrupt for a port status change event. That would mean the user could "Safely Remove" a device, have the bus suspend, disconnect the device, re-plug it in, and then the device would never be enumerated. Plugging in a different device on another port would cause the bus to resume, and khubd would notice the re-connected device. Running lsusb would also resume the bus, leading users to report the problem "went away" when using diagnostic tools. The solution is to resume the bus when a port status change event is received, regardless of the port status. Thank you very much to Maddog for helping me track down this Heisenbug. This patch should be queued for the 2.6.37 stable tree. Signed-off-by: Sarah Sharp Reported-by: Jon 'maddog' Hall Tested-by: Andiry Xu Cc: stable@kernel.org --- drivers/usb/host/xhci-ring.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/usb/host/xhci-ring.c b/drivers/usb/host/xhci-ring.c index df558f6f84e3..62c70c230e83 100644 --- a/drivers/usb/host/xhci-ring.c +++ b/drivers/usb/host/xhci-ring.c @@ -1188,7 +1188,7 @@ static void handle_port_status(struct xhci_hcd *xhci, addr = &xhci->op_regs->port_status_base + NUM_PORT_REGS * (port_id - 1); temp = xhci_readl(xhci, addr); - if ((temp & PORT_CONNECT) && (hcd->state == HC_STATE_SUSPENDED)) { + if (hcd->state == HC_STATE_SUSPENDED) { xhci_dbg(xhci, "resume root hub\n"); usb_hcd_resume_root_hub(hcd); } -- GitLab