PCI: v3-semi: Add V3 Semiconductor PCI host driver

This PCI host bridge from V3 Semiconductor needs no further
introduction. An ancient driver for it has been sitting in
arch/arm/mach-integrator/pci_v3.* since before v2.6.12 and the
initial migration to git.

But we need to get the drivers out of arch/arm/* and get proper handling of
the old drivers, rewrite and clean up so the PCI maintainer can control the
mass of drivers without having to run all over the kernel. We also switch
swiftly to all the new infrastructure found in the PCI hosts as of late.

Some code is preserved so I have added an extensive list of authors in the
top comment section.

This driver probes with the following result:

  OF: PCI: host bridge /pciv3@62000000 ranges:
  OF: PCI:   No bus range found for /pciv3@62000000, using [bus 00-ff]
  OF: PCI:    IO 0x60000000..0x6000ffff -> 0x00000000
  OF: PCI:   MEM 0x40000000..0x4fffffff -> 0x40000000
  OF: PCI:   MEM 0x50000000..0x5fffffff -> 0x50000000
  pci-v3-semi 62000000.pciv3: initialized PCI V3 Integrator/AP integration
  pci-v3-semi 62000000.pciv3: PCI host bridge to bus 0000:00
  pci_bus 0000:00: root bus resource [bus 00-ff]
  pci_bus 0000:00: root bus resource [io  0x0000-0xffff]
  pci_bus 0000:00: root bus resource [mem 0x40000000-0x4fffffff]
  pci_bus 0000:00: root bus resource [mem 0x50000000-0x5fffffff pref]
  pci-v3-semi 62000000.pciv3: parity error interrupt
  pci-v3-semi 62000000.pciv3: master abort error interrupt
  pci-v3-semi 62000000.pciv3: PCI target LB->PCI READ abort interrupt
  pci-v3-semi 62000000.pciv3: master abort error interrupt
  (repeats a few times)
  pci 0000:00:09.0: [1011:0024] type 01 class 0x060400
  pci-v3-semi 62000000.pciv3: master abort error interrupt
  pci-v3-semi 62000000.pciv3: PCI target LB->PCI READ abort interrupt
  pci 0000:00:0b.0: [8086:1229] type 00 class 0x020000
  pci 0000:00:0b.0: reg 0x10: [mem 0x00000000-0x00000fff pref]
  pci 0000:00:0b.0: reg 0x14: [io  0x0000-0x001f]
  pci 0000:00:0b.0: reg 0x18: [mem 0x00000000-0x000fffff]
  pci 0000:00:0b.0: reg 0x30: [mem 0x00000000-0x000fffff pref]
  pci 0000:00:0b.0: supports D1 D2
  pci 0000:00:0b.0: PME# supported from D0 D1 D2 D3hot
  pci 0000:00:0c.0: [5333:8811] type 00 class 0x030000
  pci 0000:00:0c.0: reg 0x10: [mem 0x00000000-0x03ffffff]
  pci 0000:00:0c.0: reg 0x30: [mem 0x00000000-0x0000ffff pref]
  pci 0000:00:0c.0: vgaarb: VGA device added: decodes=io+mem,owns=io,locks=none
  PCI: bus0: Fast back to back transfers disabled
  PCI: bus1: Fast back to back transfers enabled
  pci 0000:00:0c.0: BAR 0: assigned [mem 0x40000000-0x43ffffff]
  pci 0000:00:0b.0: BAR 2: assigned [mem 0x44000000-0x440fffff]
  pci 0000:00:0b.0: BAR 6: assigned [mem 0x50000000-0x500fffff pref]
  pci 0000:00:0c.0: BAR 6: assigned [mem 0x50100000-0x5010ffff pref]
  pci 0000:00:0b.0: BAR 0: assigned [mem 0x50110000-0x50110fff pref]
  pci 0000:00:0b.0: BAR 1: assigned [io  0x1000-0x101f]
  pci 0000:00:09.0: PCI bridge to [bus 01]
  pci 0000:00:0b.0: Firmware left e100 interrupts enabled; disabling
  (...)
  e100: Intel(R) PRO/100 Network Driver, 3.5.24-k2-NAPI
  e100: Copyright(c) 1999-2006 Intel Corporation
  e100 0000:00:0b.0: enabling device (0146 -> 0147)
  e100 0000:00:0b.0 eth0: addr 0x50110000, irq 31, MAC addr 00:08:c7:99:d2:57

> lspci
  00:0b.0 Class 0200: 8086:1229
  00:09.0 Class 0604: 1011:0024
  00:0c.0 Class 0300: 5333:8811

> cat /proc/iomem
  40000000-4fffffff : V3 PCI NON-PRE-MEM
    40000000-43ffffff : 0000:00:0c.0
    44000000-440fffff : 0000:00:0b.0
      44000000-440fffff : e100
  50000000-5fffffff : V3 PCI PRE-MEM
    50000000-500fffff : 0000:00:0b.0
    50100000-5010ffff : 0000:00:0c.0
    50110000-50110fff : 0000:00:0b.0
      50110000-50110fff : e100
  61000000-61ffffff : /pciv3@62000000
  62000000-6200ffff : /pciv3@62000000
Signed-off-by: NLinus Walleij <linus.walleij@linaro.org>
[bhelgaas: fold in %pR fixes from Arnd Bergmann <arnd@arndb.de>:
http://lkml.kernel.org/r/20171011140224.3770968-1-arnd@arndb.de]
Signed-off-by: NBjorn Helgaas <bhelgaas@google.com>
CC: Marc Gonzalez <marc_gonzalez@sigmadesigns.com>

MAINTAINERS

@@ -10503,6 +10503,13 @@ S:	Maintained
 F:	Documentation/devicetree/bindings/pci/rockchip-pcie.txt
 F:	drivers/pci/host/pcie-rockchip.c
 
+PCI DRIVER FOR V3 SEMICONDUCTOR V360EPC
+M:	Linus Walleij <linus.walleij@linaro.org>
+L:	linux-pci@vger.kernel.org
+S:	Maintained
+F:	Documentation/devicetree/bindings/pci/v3-v360epc-pci.txt
+F:	drivers/pci/host/pci-v3-semi.c
+
 PCIE DRIVER FOR ST SPEAR13XX
 M:	Pratyush Anand <pratyush.anand@gmail.com>
 L:	linux-pci@vger.kernel.org

drivers/pci/host/Kconfig

@@ -95,6 +95,12 @@ config PCI_XGENE_MSI
 	  Say Y here if you want PCIe MSI support for the APM X-Gene v1 SoC.
 	  This MSI driver supports 5 PCIe ports on the APM X-Gene v1 SoC.
 
+config PCI_V3_SEMI
+	bool "V3 Semiconductor PCI controller"
+	depends on OF
+	depends on ARM
+	default ARCH_INTEGRATOR_AP
+
 config PCI_VERSATILE
 	bool "ARM Versatile PB PCI controller"
 	depends on ARCH_VERSATILE

drivers/pci/host/Makefile

@@ -9,6 +9,7 @@ obj-$(CONFIG_PCI_HOST_COMMON) += pci-host-common.o
 obj-$(CONFIG_PCI_HOST_GENERIC) += pci-host-generic.o
 obj-$(CONFIG_PCIE_XILINX) += pcie-xilinx.o
 obj-$(CONFIG_PCIE_XILINX_NWL) += pcie-xilinx-nwl.o
+obj-$(CONFIG_PCI_V3_SEMI) += pci-v3-semi.o
 obj-$(CONFIG_PCI_XGENE_MSI) += pci-xgene-msi.o
 obj-$(CONFIG_PCI_VERSATILE) += pci-versatile.o
 obj-$(CONFIG_PCIE_IPROC) += pcie-iproc.o