From 092e1fdaf35126475aef0dc70f4a2ce4f2f43052 Mon Sep 17 00:00:00 2001 From: Bryan Wu Date: Tue, 4 Dec 2007 23:45:23 -0800 Subject: [PATCH] Blackfin SPI driver: reconfigure speed_hz and bits_per_word in each spi transfer - reconfigure SPI baud from speed_hz of each spi transfer - according to spi_transfer.bits_per_word to reprogram register and setup correct SPI operation handlers Signed-off-by: Bryan Wu Cc: David Brownell Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds --- drivers/spi/spi_bfin5xx.c | 52 +++++++++++++++++++++++++++++++++------ 1 file changed, 45 insertions(+), 7 deletions(-) diff --git a/drivers/spi/spi_bfin5xx.c b/drivers/spi/spi_bfin5xx.c index d6e9812538c4..22697b812205 100644 --- a/drivers/spi/spi_bfin5xx.c +++ b/drivers/spi/spi_bfin5xx.c @@ -234,10 +234,8 @@ static int restore_state(struct driver_data *drv_data) dev_dbg(&drv_data->pdev->dev, "restoring spi ctl state\n"); /* Load the registers */ - write_BAUD(drv_data, chip->baud); - chip->ctl_reg &= (~BIT_CTL_TIMOD); - chip->ctl_reg |= (chip->width << 8); write_CTRL(drv_data, chip->ctl_reg); + write_BAUD(drv_data, chip->baud); bfin_spi_enable(drv_data); cs_active(drv_data, chip); @@ -679,6 +677,7 @@ static void pump_transfers(unsigned long data) message = drv_data->cur_msg; transfer = drv_data->cur_transfer; chip = drv_data->cur_chip; + /* * if msg is error or done, report it back using complete() callback */ @@ -736,15 +735,48 @@ static void pump_transfers(unsigned long data) drv_data->len_in_bytes = transfer->len; drv_data->cs_change = transfer->cs_change; - width = chip->width; + /* Bits per word setup */ + switch (transfer->bits_per_word) { + case 8: + drv_data->n_bytes = 1; + width = CFG_SPI_WORDSIZE8; + drv_data->read = chip->cs_change_per_word ? + u8_cs_chg_reader : u8_reader; + drv_data->write = chip->cs_change_per_word ? + u8_cs_chg_writer : u8_writer; + drv_data->duplex = chip->cs_change_per_word ? + u8_cs_chg_duplex : u8_duplex; + break; + + case 16: + drv_data->n_bytes = 2; + width = CFG_SPI_WORDSIZE16; + drv_data->read = chip->cs_change_per_word ? + u16_cs_chg_reader : u16_reader; + drv_data->write = chip->cs_change_per_word ? + u16_cs_chg_writer : u16_writer; + drv_data->duplex = chip->cs_change_per_word ? + u16_cs_chg_duplex : u16_duplex; + break; + + default: + /* No change, the same as default setting */ + drv_data->n_bytes = chip->n_bytes; + width = chip->width; + drv_data->write = drv_data->tx ? chip->write : null_writer; + drv_data->read = drv_data->rx ? chip->read : null_reader; + drv_data->duplex = chip->duplex ? chip->duplex : null_writer; + break; + } + cr = (read_CTRL(drv_data) & (~BIT_CTL_TIMOD)); + cr |= (width << 8); + write_CTRL(drv_data, cr); + if (width == CFG_SPI_WORDSIZE16) { drv_data->len = (transfer->len) >> 1; } else { drv_data->len = transfer->len; } - drv_data->write = drv_data->tx ? chip->write : null_writer; - drv_data->read = drv_data->rx ? chip->read : null_reader; - drv_data->duplex = chip->duplex ? chip->duplex : null_writer; dev_dbg(&drv_data->pdev->dev, "transfer: ", "drv_data->write is %p, chip->write is %p, null_wr is %p\n", drv_data->write, chip->write, null_writer); @@ -753,6 +785,12 @@ static void pump_transfers(unsigned long data) message->state = RUNNING_STATE; dma_config = 0; + /* Speed setup (surely valid because already checked) */ + if (transfer->speed_hz) + write_BAUD(drv_data, hz_to_spi_baud(transfer->speed_hz)); + else + write_BAUD(drv_data, chip->baud); + write_STAT(drv_data, BIT_STAT_CLR); cr = (read_CTRL(drv_data) & (~BIT_CTL_TIMOD)); cs_active(drv_data, chip); -- GitLab