tcg/sparc: Zero extend address argument to ld/st helpers

The C store helper functions take the address argument as a
target_ulong type; if this is 32 bit but the host is 64 bit
then the SPARC calling convention requires that the caller
must zero extend the value. We weren't doing this, which
meant we could pass values to the caller with high bits set
and QEMU would crash if it was compiled with optimizations.
In particular, the i386 BIOS would not start.
Signed-off-by: NPeter Maydell <peter.maydell@linaro.org>
Message-id: 1490871151-29029-3-git-send-email-peter.maydell@linaro.org
Reviewed-by: NRichard Henderson <rth@twiddle.net>

tcg/sparc/tcg-target.inc.c

@@ -1144,7 +1144,7 @@ static void tcg_out_qemu_ld(TCGContext *s, TCGReg data, TCGReg addr,
         /* Skip the high-part; we'll perform the extract in the trampoline.  */
         param++;
     }
-    tcg_out_mov(s, TCG_TYPE_REG, param++, addr);
+    tcg_out_mov(s, TCG_TYPE_REG, param++, addrz);
 
     /* We use the helpers to extend SB and SW data, leaving the case
        of SL needing explicit extending below.  */
@@ -1224,7 +1224,7 @@ static void tcg_out_qemu_st(TCGContext *s, TCGReg data, TCGReg addr,
         /* Skip the high-part; we'll perform the extract in the trampoline.  */
         param++;
     }
-    tcg_out_mov(s, TCG_TYPE_REG, param++, addr);
+    tcg_out_mov(s, TCG_TYPE_REG, param++, addrz);
     if (!SPARC64 && (memop & MO_SIZE) == MO_64) {
         /* Skip the high-part; we'll perform the extract in the trampoline.  */
         param++;