Skip to content

K
Kernel

openeuler / Kernel
大约 1 年 前同步成功

通知 5
Star 0
Fork 0
K
Kernel

体验新版 GitCode，发现更多精彩内容 >>

切换分支/标签
  1. 06 2月, 2009 3 次提交
    • N
      md: Ensure an md array never has too many devices. · de01dfad
      由 NeilBrown 提交于 
      Each different metadata format supported by md supports a
different maximum number of devices.
We really should be enforcing this maximum in the kernel, but
we aren't quite doing that properly.

We currently only enforce it at the 'hot_add' point, which is an
older interface which is not used by current userspace.

We need to also enforce it at 'add_new_disk' time for active arrays
and at 'do_md_run' time when starting a new array.

So move the test from 'hot_add' into 'bind_rdev_to_array' which is
called from both 'hot_add' and 'add_new_disk, and add a new
test in 'analyse_sbs' which is called from 'do_md_run'.

This bug (or missing feature) has been around "forever" and so
the patch is suitable for any -stable that is currently maintained.

Cc: stable@kernel.org
Signed-off-by: NNeilBrown <neilb@suse.de>
      de01dfad
    • A
      md: Fix a bug in linear.c causing which_dev() to return the wrong device. · 852c8bf4
      由 Andre Noll 提交于 
      ab5bd5cb introduced the following
bug in linear software raid for large arrays on 32 bit machines:

which_dev() computes the device holding a given sector by shifting
down the sector number to a 32 bit range, dividing by the array
spacing and looking up the resulting index in the hash table of
the array.

Because the computed index might be slightly too small, a loop at
the end of which_dev() increases the index until the given sector
actually falls into the range of the device associated with that index.

The changes of the above mentioned commit caused this loop to check
whether the _index_ rather than the sector number is small enough,
effectively bypassing the loop and thus possibly returning the wrong
device.

As reported by Simon Kirby, this leads to errors such as

	linear_make_request: Sector 2340486136 out of bounds on dev sdi: 156301312 sectors, offset 2109870464

Fix this bug by introducing a local variable for the index so that
the variable containing the passed sector is left unchanged.

Cc: stable@kernel.org
Signed-off-by: NAndre Noll <maan@systemlinux.org>
Signed-off-by: NNeilBrown <neilb@suse.de>
      852c8bf4
    • N
      md: Allow read error in a single drive raid1 to be passed up. · 4706b349
      由 NeilBrown 提交于 
      If a raid1 only has a single working device and gets a read error, 
we choose to simply return that error up to the filesystem (or whatever)
rather than failing the whole array.

However the codes doesn't quite do that.  We attempt a readbalance
which allocates the same drive, so we retry the read - indefinitely. 

Instead:  If read_balance in the error case chooses the same drive that just
failed, treat it as a failure and don't retry.
Signed-off-by: NNeilBrown <neilb@suse.de>
      4706b349
  3. 04 2月, 2009 37 次提交