Sparsemem abstracts the use of discontiguous mem_maps[].  This kind of
mem_map[] is needed by discontiguous memory machines (like in the old
CONFIG_DISCONTIGMEM case) as well as memory hotplug systems.  Sparsemem
replaces DISCONTIGMEM when enabled, and it is hoped that it can eventually
become a complete replacement.

A significant advantage over DISCONTIGMEM is that it's completely separated
from CONFIG_NUMA.  When producing this patch, it became apparent in that NUMA
and DISCONTIG are often confused.

Another advantage is that sparse doesn't require each NUMA node's ranges to be
contiguous.  It can handle overlapping ranges between nodes with no problems,
where DISCONTIGMEM currently throws away that memory.

Sparsemem uses an array to provide different pfn_to_page() translations for
each SECTION_SIZE area of physical memory.  This is what allows the mem_map[]
to be chopped up.

In order to do quick pfn_to_page() operations, the section number of the page
is encoded in page->flags.  Part of the sparsemem infrastructure enables
sharing of these bits more dynamically (at compile-time) between the
page_zone() and sparsemem operations.  However, on 32-bit architectures, the
number of bits is quite limited, and may require growing the size of the
page->flags type in certain conditions.  Several things might force this to
occur: a decrease in the SECTION_SIZE (if you want to hotplug smaller areas of
memory), an increase in the physical address space, or an increase in the
number of used page->flags.

One thing to note is that, once sparsemem is present, the NUMA node
information no longer needs to be stored in the page->flags.  It might provide
speed increases on certain platforms and will be stored there if there is
room.  But, if out of room, an alternate (theoretically slower) mechanism is
used.

This patch introduces CONFIG_FLATMEM.  It is used in almost all cases where
there used to be an #ifndef DISCONTIG, because SPARSEMEM and DISCONTIGMEM
often have to compile out the same areas of code.
Signed-off-by: NAndy Whitcroft <apw@shadowen.org>
Signed-off-by: NDave Hansen <haveblue@us.ibm.com>
Signed-off-by: NMartin Bligh <mbligh@aracnet.com>
Signed-off-by: NAdrian Bunk <bunk@stusta.de>
Signed-off-by: NYasunori Goto <y-goto@jp.fujitsu.com>
Signed-off-by: NBob Picco <bob.picco@hp.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!