Skip to content

K
Kernel

openeuler / Kernel
大约 1 年 前同步成功

通知 5
Star 0
Fork 0
K
Kernel

体验新版 GitCode，发现更多精彩内容 >>

切换分支/标签
  1. 15 10月, 2007 7 次提交
  3. 01 10月, 2007 2 次提交
  5. 20 9月, 2007 2 次提交
    • C
      [XFS] fix valid but harmless sparse warning · 1bc5858d
      由 Christoph Hellwig 提交于 
      The new xlog_recover_do_reg_buffer checks call be16_to_cpu on di_gen which
is a 32bit value so sparse rightly complains. Fortunately the warning is
harmless because we don't care for the value, but only whether it's
non-NULL. Due to that fact we can simply kill the endian swaps on this and
the previous di_mode check entirely.

SGI-PV: 969656
SGI-Modid: xfs-linux-melb:xfs-kern:29709a
Signed-off-by: NChristoph Hellwig <hch@infradead.org>
Signed-off-by: NLachlan McIlroy <lachlan@sgi.com>
Signed-off-by: NTim Shimmin <tes@sgi.com>
      1bc5858d
    • E
      [XFS] fix filestreams on 32-bit boxes · bcc7b445
      由 Eric Sandeen 提交于 
      xfs_filestream_mount() sets up an mru cache with:
  err = xfs_mru_cache_create(&mp->m_filestream, lifetime, grp_count,
  (xfs_mru_cache_free_func_t)xfs_fstrm_free_func);
but that cast is causing problems...
  typedef void (*xfs_mru_cache_free_func_t)(unsigned long, void*);
but:
  void xfs_fstrm_free_func( xfs_ino_t ino, fstrm_item_t *item)
so on a 32-bit box, it's casting (32, 32) args into (64, 32) and I assume
it's getting garbage for *item, which subsequently causes an explosion.
With this change the filestreams xfsqa tests don't oops on my 32-bit box.

SGI-PV: 967795
SGI-Modid: xfs-linux-melb:xfs-kern:29510a
Signed-off-by: NEric Sandeen <sandeen@sandeen.net>
Signed-off-by: NDavid Chinner <dgc@sgi.com>
Signed-off-by: NTim Shimmin <tes@sgi.com>
      bcc7b445
  7. 18 9月, 2007 2 次提交
  9. 17 9月, 2007 1 次提交
  11. 05 9月, 2007 6 次提交
  13. 27 7月, 2007 1 次提交
  15. 20 7月, 2007 4 次提交
    • P
      mm: Remove slab destructors from kmem_cache_create(). · 20c2df83
      由 Paul Mundt 提交于 
      Slab destructors were no longer supported after Christoph's
c59def9f change. They've been
BUGs for both slab and slub, and slob never supported them
either.

This rips out support for the dtor pointer from kmem_cache_create()
completely and fixes up every single callsite in the kernel (there were
about 224, not including the slab allocator definitions themselves,
or the documentation references).
Signed-off-by: NPaul Mundt <lethal@linux-sh.org>
      20c2df83
    • N
      mm: fault feedback #1 · d0217ac0
      由 Nick Piggin 提交于 
      Change ->fault prototype.  We now return an int, which contains
VM_FAULT_xxx code in the low byte, and FAULT_RET_xxx code in the next byte.
 FAULT_RET_ code tells the VM whether a page was found, whether it has been
locked, and potentially other things.  This is not quite the way he wanted
it yet, but that's changed in the next patch (which requires changes to
arch code).

This means we no longer set VM_CAN_INVALIDATE in the vma in order to say
that a page is locked which requires filemap_nopage to go away (because we
can no longer remain backward compatible without that flag), but we were
going to do that anyway.

struct fault_data is renamed to struct vm_fault as Linus asked. address
is now a void __user * that we should firmly encourage drivers not to use
without really good reason.

The page is now returned via a page pointer in the vm_fault struct.
Signed-off-by: NNick Piggin <npiggin@suse.de>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      d0217ac0
    • N
      mm: merge populate and nopage into fault (fixes nonlinear) · 54cb8821
      由 Nick Piggin 提交于 
      Nonlinear mappings are (AFAIKS) simply a virtual memory concept that encodes
the virtual address -> file offset differently from linear mappings.

->populate is a layering violation because the filesystem/pagecache code
should need to know anything about the virtual memory mapping.  The hitch here
is that the ->nopage handler didn't pass down enough information (ie.  pgoff).
 But it is more logical to pass pgoff rather than have the ->nopage function
calculate it itself anyway (because that's a similar layering violation).

Having the populate handler install the pte itself is likewise a nasty thing
to be doing.

This patch introduces a new fault handler that replaces ->nopage and
->populate and (later) ->nopfn.  Most of the old mechanism is still in place
so there is a lot of duplication and nice cleanups that can be removed if
everyone switches over.

The rationale for doing this in the first place is that nonlinear mappings are
subject to the pagefault vs invalidate/truncate race too, and it seemed stupid
to duplicate the synchronisation logic rather than just consolidate the two.

After this patch, MAP_NONBLOCK no longer sets up ptes for pages present in
pagecache.  Seems like a fringe functionality anyway.

NOPAGE_REFAULT is removed.  This should be implemented with ->fault, and no
users have hit mainline yet.

[akpm@linux-foundation.org: cleanup]
[randy.dunlap@oracle.com: doc. fixes for readahead]
[akpm@linux-foundation.org: build fix]
Signed-off-by: NNick Piggin <npiggin@suse.de>
Signed-off-by: NRandy Dunlap <randy.dunlap@oracle.com>
Cc: Mark Fasheh <mark.fasheh@oracle.com>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      54cb8821
    • N
      mm: fix fault vs invalidate race for linear mappings · d00806b1
      由 Nick Piggin 提交于 
      Fix the race between invalidate_inode_pages and do_no_page.

Andrea Arcangeli identified a subtle race between invalidation of pages from
pagecache with userspace mappings, and do_no_page.

The issue is that invalidation has to shoot down all mappings to the page,
before it can be discarded from the pagecache.  Between shooting down ptes to
a particular page, and actually dropping the struct page from the pagecache,
do_no_page from any process might fault on that page and establish a new
mapping to the page just before it gets discarded from the pagecache.

The most common case where such invalidation is used is in file truncation.
This case was catered for by doing a sort of open-coded seqlock between the
file's i_size, and its truncate_count.

Truncation will decrease i_size, then increment truncate_count before
unmapping userspace pages; do_no_page will read truncate_count, then find the
page if it is within i_size, and then check truncate_count under the page
table lock and back out and retry if it had subsequently been changed (ptl
will serialise against unmapping, and ensure a potentially updated
truncate_count is actually visible).

Complexity and documentation issues aside, the locking protocol fails in the
case where we would like to invalidate pagecache inside i_size.  do_no_page
can come in anytime and filemap_nopage is not aware of the invalidation in
progress (as it is when it is outside i_size).  The end result is that
dangling (->mapping == NULL) pages that appear to be from a particular file
may be mapped into userspace with nonsense data.  Valid mappings to the same
place will see a different page.

Andrea implemented two working fixes, one using a real seqlock, another using
a page->flags bit.  He also proposed using the page lock in do_no_page, but
that was initially considered too heavyweight.  However, it is not a global or
per-file lock, and the page cacheline is modified in do_no_page to increment
_count and _mapcount anyway, so a further modification should not be a large
performance hit.  Scalability is not an issue.

This patch implements this latter approach.  ->nopage implementations return
with the page locked if it is possible for their underlying file to be
invalidated (in that case, they must set a special vm_flags bit to indicate
so).  do_no_page only unlocks the page after setting up the mapping
completely.  invalidation is excluded because it holds the page lock during
invalidation of each page (and ensures that the page is not mapped while
holding the lock).

This also allows significant simplifications in do_no_page, because we have
the page locked in the right place in the pagecache from the start.
Signed-off-by: NNick Piggin <npiggin@suse.de>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      d00806b1
  17. 19 7月, 2007 3 次提交
  19. 18 7月, 2007 3 次提交
    • C
      knfsd: exportfs: add exportfs.h header · a5694255
      由 Christoph Hellwig 提交于 
      currently the export_operation structure and helpers related to it are in
fs.h.  fs.h is already far too large and there are very few places needing the
export bits, so split them off into a separate header.

[akpm@linux-foundation.org: fix cifs build]
Signed-off-by: NChristoph Hellwig <hch@lst.de>
Signed-off-by: NNeil Brown <neilb@suse.de>
Cc: Steven French <sfrench@us.ibm.com>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      a5694255
    • R
      Freezer: make kernel threads nonfreezable by default · 83144186
      由 Rafael J. Wysocki 提交于 
      Currently, the freezer treats all tasks as freezable, except for the kernel
threads that explicitly set the PF_NOFREEZE flag for themselves.  This
approach is problematic, since it requires every kernel thread to either
set PF_NOFREEZE explicitly, or call try_to_freeze(), even if it doesn't
care for the freezing of tasks at all.

It seems better to only require the kernel threads that want to or need to
be frozen to use some freezer-related code and to remove any
freezer-related code from the other (nonfreezable) kernel threads, which is
done in this patch.

The patch causes all kernel threads to be nonfreezable by default (ie.  to
have PF_NOFREEZE set by default) and introduces the set_freezable()
function that should be called by the freezable kernel threads in order to
unset PF_NOFREEZE.  It also makes all of the currently freezable kernel
threads call set_freezable(), so it shouldn't cause any (intentional)
change of behaviour to appear.  Additionally, it updates documentation to
describe the freezing of tasks more accurately.

[akpm@linux-foundation.org: build fixes]
Signed-off-by: NRafael J. Wysocki <rjw@sisk.pl>
Acked-by: NNigel Cunningham <nigel@nigel.suspend2.net>
Cc: Pavel Machek <pavel@ucw.cz>
Cc: Oleg Nesterov <oleg@tv-sign.ru>
Cc: Gautham R Shenoy <ego@in.ibm.com>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      83144186
    • R
      mm: clean up and kernelify shrinker registration · 8e1f936b
      由 Rusty Russell 提交于 
      I can never remember what the function to register to receive VM pressure
is called.  I have to trace down from __alloc_pages() to find it.

It's called "set_shrinker()", and it needs Your Help.

1) Don't hide struct shrinker.  It contains no magic.
2) Don't allocate "struct shrinker".  It's not helpful.
3) Call them "register_shrinker" and "unregister_shrinker".
4) Call the function "shrink" not "shrinker".
5) Reduce the 17 lines of waffly comments to 13, but document it properly.
Signed-off-by: NRusty Russell <rusty@rustcorp.com.au>
Cc: David Chinner <dgc@sgi.com>
Cc: Trond Myklebust <trond.myklebust@fys.uio.no>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      8e1f936b
  21. 14 7月, 2007 9 次提交