i2c: designware: Keep pm_runtime_enable/_disable calls in sync

On an hardware shared I2C bus (certain Intel Baytrail SoC platforms) the
runtime PM disable depth keeps increasing over repeated modprobe/rmmod
cycle because pm_runtime_disable() is called without checking should it
be disabled already because of bus sharing.

This hasn't made any other harm than dev->power.disable_depth keeps
increasing but keep it sync by calling pm_runtime_disable() only when
runtime PM is not disabled.
Reported-by: NWolfram Sang <wsa@the-dreams.de>
Signed-off-by: NJarkko Nikula <jarkko.nikula@linux.intel.com>
Signed-off-by: NWolfram Sang <wsa@the-dreams.de>

drivers/i2c/busses/i2c-designware-platdrv.c

@@ -245,12 +245,10 @@ static int dw_i2c_plat_probe(struct platform_device *pdev)
 	}
 
 	r = i2c_dw_probe(dev);
-	if (r) {
+	if (r && !dev->pm_runtime_disabled)
 		pm_runtime_disable(&pdev->dev);
-		return r;
-	}
 
-	return 0;
+	return r;
 }
 
 static int dw_i2c_plat_remove(struct platform_device *pdev)
@@ -265,6 +263,7 @@ static int dw_i2c_plat_remove(struct platform_device *pdev)
 
 	pm_runtime_dont_use_autosuspend(&pdev->dev);
 	pm_runtime_put_sync(&pdev->dev);
+	if (!dev->pm_runtime_disabled)
 		pm_runtime_disable(&pdev->dev);
 
 	return 0;