From c8c1b39a86940edd35439f1e5c9ff39888daf0f0 Mon Sep 17 00:00:00 2001 From: Andrew Lunn Date: Fri, 20 Nov 2015 03:56:24 +0100 Subject: [PATCH] dsa: mv88e6xxx.c: Hardware reset the chip if available The device tree binding now allows a gpio to be specified which is attached to the switch chips reset line. If it is defined, perform a hardware reset on the switch during setup. Signed-off-by: Andrew Lunn Signed-off-by: David S. Miller --- drivers/net/dsa/mv88e6xxx.c | 10 ++++++++++ 1 file changed, 10 insertions(+) diff --git a/drivers/net/dsa/mv88e6xxx.c b/drivers/net/dsa/mv88e6xxx.c index b06dba05594a..75e245c4235e 100644 --- a/drivers/net/dsa/mv88e6xxx.c +++ b/drivers/net/dsa/mv88e6xxx.c @@ -19,6 +19,7 @@ #include #include #include +#include #include #include #include @@ -2323,6 +2324,7 @@ int mv88e6xxx_switch_reset(struct dsa_switch *ds, bool ppu_active) { struct mv88e6xxx_priv_state *ps = ds_to_priv(ds); u16 is_reset = (ppu_active ? 0x8800 : 0xc800); + struct gpio_desc *gpiod = ds->pd->reset; unsigned long timeout; int ret; int i; @@ -2336,6 +2338,14 @@ int mv88e6xxx_switch_reset(struct dsa_switch *ds, bool ppu_active) /* Wait for transmit queues to drain. */ usleep_range(2000, 4000); + /* If there is a gpio connected to the reset pin, toggle it */ + if (gpiod) { + gpiod_set_value_cansleep(gpiod, 1); + usleep_range(10000, 20000); + gpiod_set_value_cansleep(gpiod, 0); + usleep_range(10000, 20000); + } + /* Reset the switch. Keep the PPU active if requested. The PPU * needs to be active to support indirect phy register access * through global registers 0x18 and 0x19. -- GitLab