mm, THP, swap: support to clear swap cache flag for THP swapped out

Patch series "mm, THP, swap: Delay splitting THP after swapped out", v3.

This is the second step of THP (Transparent Huge Page) swap
optimization.  In the first step, the splitting huge page is delayed
from almost the first step of swapping out to after allocating the swap
space for the THP and adding the THP into the swap cache.  In the second
step, the splitting is delayed further to after the swapping out
finished.  The plan is to delay splitting THP step by step, finally
avoid splitting THP for the THP swapping out and swap out/in the THP as
a whole.

In the patchset, more operations for the anonymous THP reclaiming, such
as TLB flushing, writing the THP to the swap device, removing the THP
from the swap cache are batched.  So that the performance of anonymous
THP swapping out are improved.

During the development, the following scenarios/code paths have been
checked,

 - swap out/in
 - swap off
 - write protect page fault
 - madvise_free
 - process exit
 - split huge page

With the patchset, the swap out throughput improves 42% (from about
5.81GB/s to about 8.25GB/s) in the vm-scalability swap-w-seq test case
with 16 processes.  At the same time, the IPI (reflect TLB flushing)
reduced about 78.9%.  The test is done on a Xeon E5 v3 system.  The swap
device used is a RAM simulated PMEM (persistent memory) device.  To test
the sequential swapping out, the test case creates 8 processes, which
sequentially allocate and write to the anonymous pages until the RAM and
part of the swap device is used up.

Below is the part of the cover letter for the first step patchset of THP
swap optimization which applies to all steps.

=========================

Recently, the performance of the storage devices improved so fast that
we cannot saturate the disk bandwidth with single logical CPU when do
page swap out even on a high-end server machine.  Because the
performance of the storage device improved faster than that of single
logical CPU.  And it seems that the trend will not change in the near
future.  On the other hand, the THP becomes more and more popular
because of increased memory size.  So it becomes necessary to optimize
THP swap performance.

The advantages of the THP swap support include:

 - Batch the swap operations for the THP to reduce TLB flushing and lock
   acquiring/releasing, including allocating/freeing the swap space,
   adding/deleting to/from the swap cache, and writing/reading the swap
   space, etc. This will help improve the performance of the THP swap.

 - The THP swap space read/write will be 2M sequential IO. It is
   particularly helpful for the swap read, which are usually 4k random
   IO. This will improve the performance of the THP swap too.

 - It will help the memory fragmentation, especially when the THP is
   heavily used by the applications. The 2M continuous pages will be
   free up after THP swapping out.

 - It will improve the THP utilization on the system with the swap
   turned on. Because the speed for khugepaged to collapse the normal
   pages into the THP is quite slow. After the THP is split during the
   swapping out, it will take quite long time for the normal pages to
   collapse back into the THP after being swapped in. The high THP
   utilization helps the efficiency of the page based memory management
   too.

There are some concerns regarding THP swap in, mainly because possible
enlarged read/write IO size (for swap in/out) may put more overhead on
the storage device.  To deal with that, the THP swap in should be turned
on only when necessary.

For example, it can be selected via "always/never/madvise" logic, to be
turned on globally, turned off globally, or turned on only for VMA with
MADV_HUGEPAGE, etc.

This patch (of 12):

Previously, swapcache_free_cluster() is used only in the error path of
shrink_page_list() to free the swap cluster just allocated if the THP
(Transparent Huge Page) is failed to be split.  In this patch, it is
enhanced to clear the swap cache flag (SWAP_HAS_CACHE) for the swap
cluster that holds the contents of THP swapped out.

This will be used in delaying splitting THP after swapping out support.
Because there is no THP swapping in as a whole support yet, after
clearing the swap cache flag, the swap cluster backing the THP swapped
out will be split.  So that the swap slots in the swap cluster can be
swapped in as normal pages later.

Link: http://lkml.kernel.org/r/20170724051840.2309-2-ying.huang@intel.comSigned-off-by: N"Huang, Ying" <ying.huang@intel.com>
Acked-by: NRik van Riel <riel@redhat.com>
Cc: Johannes Weiner <hannes@cmpxchg.org>
Cc: Minchan Kim <minchan@kernel.org>
Cc: Hugh Dickins <hughd@google.com>
Cc: Shaohua Li <shli@kernel.org>
Cc: "Kirill A . Shutemov" <kirill.shutemov@linux.intel.com>
Cc: Andrea Arcangeli <aarcange@redhat.com>
Cc: Dan Williams <dan.j.williams@intel.com>
Cc: Jens Axboe <axboe@kernel.dk>
Cc: Michal Hocko <mhocko@kernel.org>
Cc: Ross Zwisler <ross.zwisler@intel.com> [for brd.c, zram_drv.c, pmem.c]
Cc: Vishal L Verma <vishal.l.verma@intel.com>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

mm/swapfile.c

@@ -1168,22 +1168,40 @@ static void swapcache_free_cluster(swp_entry_t entry)
 	struct swap_cluster_info *ci;
 	struct swap_info_struct *si;
 	unsigned char *map;
-	unsigned int i;
+	unsigned int i, free_entries = 0;
+	unsigned char val;
 
-	si = swap_info_get(entry);
+	si = _swap_info_get(entry);
 	if (!si)
 		return;
 
 	ci = lock_cluster(si, offset);
 	map = si->swap_map + offset;
 	for (i = 0; i < SWAPFILE_CLUSTER; i++) {
-		VM_BUG_ON(map[i] != SWAP_HAS_CACHE);
-		map[i] = 0;
+		val = map[i];
+		VM_BUG_ON(!(val & SWAP_HAS_CACHE));
+		if (val == SWAP_HAS_CACHE)
+			free_entries++;
+	}
+	if (!free_entries) {
+		for (i = 0; i < SWAPFILE_CLUSTER; i++)
+			map[i] &= ~SWAP_HAS_CACHE;
 	}
 	unlock_cluster(ci);
+	if (free_entries == SWAPFILE_CLUSTER) {
+		spin_lock(&si->lock);
+		ci = lock_cluster(si, offset);
+		memset(map, 0, SWAPFILE_CLUSTER);
+		unlock_cluster(ci);
 		mem_cgroup_uncharge_swap(entry, SWAPFILE_CLUSTER);
 		swap_free_cluster(si, idx);
 		spin_unlock(&si->lock);
+	} else if (free_entries) {
+		for (i = 0; i < SWAPFILE_CLUSTER; i++, entry.val++) {
+			if (!__swap_entry_free(si, entry, SWAP_HAS_CACHE))
+				free_swap_slot(entry);
+		}
+	}
 }
 #else
 static inline void swapcache_free_cluster(swp_entry_t entry)