spi: pic32: Convert to use GPIO descriptors

The driver already relies on the core looking up GPIO lines
from the core, so this is trivial to switch over to using
GPIO descriptors.

Cc: Purna Chandra Mandal <purna.mandal@microchip.com>
Signed-off-by: NLinus Walleij <linus.walleij@linaro.org>
Link: https://lore.kernel.org/r/20220122004846.374930-1-linus.walleij@linaro.orgSigned-off-by: NMark Brown <broonie@kernel.org>

drivers/spi/spi-pic32.c

@@ -591,18 +591,16 @@ static int pic32_spi_setup(struct spi_device *spi)
 	 * unreliable/erroneous SPI transactions.
 	 * To avoid that we will always handle /CS by toggling GPIO.
 	 */
-	if (!gpio_is_valid(spi->cs_gpio))
+	if (!spi->cs_gpiod)
 		return -EINVAL;
 
-	gpio_direction_output(spi->cs_gpio, !(spi->mode & SPI_CS_HIGH));
-
 	return 0;
 }
 
 static void pic32_spi_cleanup(struct spi_device *spi)
 {
-	/* de-activate cs-gpio */
-	gpio_direction_output(spi->cs_gpio, !(spi->mode & SPI_CS_HIGH));
+	/* de-activate cs-gpio, gpiolib will handle inversion */
+	gpiod_direction_output(spi->cs_gpiod, 0);
 }
 
 static int pic32_spi_dma_prep(struct pic32_spi *pic32s, struct device *dev)
@@ -784,6 +782,7 @@ static int pic32_spi_probe(struct platform_device *pdev)
 	master->unprepare_message	= pic32_spi_unprepare_message;
 	master->prepare_transfer_hardware	= pic32_spi_prepare_hardware;
 	master->unprepare_transfer_hardware	= pic32_spi_unprepare_hardware;
+	master->use_gpio_descriptors = true;
 
 	/* optional DMA support */
 	ret = pic32_spi_dma_prep(pic32s, &pdev->dev);