dmaengine: make slave address physical

The slave dmaengine semantics required the client to map dma
addresses and pass DMA address to dmaengine drivers. This
was a convenient notion coming from generic dma offload cases
where dmaengines are interchangeable and client is not aware of
which engine to map to.

But in case of slave, we know the dmaengine and always use a
specific one. Further the IOMMU cases can lead to failure of this
notion, so make this as physical address and now dmaengine driver
will do the required mapping.
Original-patch-by: NLinus Walleij <linus.walleij@linaro.org>
Original-patch-Acked-by: NLee Jones <lee.jones@linaro.org>
Reviewed-by: NLaurent Pinchart <laurent.pinchart@ideasonboard.com>
Acked-by: NArnd Bergmann <arnd@arndb.de>
Acked-by: NGeert Uytterhoeven <geert+renesas@glider.be>
Acked-by: NWolfram Sang <wsa+renesas@sang-engineering.com>
Tested-by: NWolfram Sang <wsa+renesas@sang-engineering.com>
Tested-by: NNiklas Söderlund <niklas.soderlund+renesas@ragnatech.se>
Signed-off-by: NVinod Koul <vinod.koul@intel.com>

include/linux/dmaengine.h

@@ -357,8 +357,8 @@ enum dma_slave_buswidth {
  */
 struct dma_slave_config {
 	enum dma_transfer_direction direction;
-	dma_addr_t src_addr;
-	dma_addr_t dst_addr;
+	phys_addr_t src_addr;
+	phys_addr_t dst_addr;
 	enum dma_slave_buswidth src_addr_width;
 	enum dma_slave_buswidth dst_addr_width;
 	u32 src_maxburst;