From 8b0162a3dc5c30e862b7a73da29e32de3170f5e4 Mon Sep 17 00:00:00 2001
From: Felix Fietkau <nbd@openwrt.org>
Date: Mon, 3 Nov 2008 11:27:38 +0100
Subject: [PATCH] ath5k: ignore the return value of
 ath5k_hw_noise_floor_calibration

Noise floor calibration occasionally fails on Atheros hardware.
This is not fatal and can happen if there's simply too much
noise on the air. Ignoring the calibration error is the right
thing to do here, because when the error is ignored, the hardware
will still work, whereas if the error causes the driver to bail out
of a bigger configuration function and does not configure the tx
queues or the IMR (as is the case in reset.c), the hw no longer
works properly until the next reset.

Signed-off-by: Felix Fietkau <nbd@openwrt.org>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
---
 drivers/net/wireless/ath5k/phy.c   | 4 +---
 drivers/net/wireless/ath5k/reset.c | 4 +---
 2 files changed, 2 insertions(+), 6 deletions(-)

diff --git a/drivers/net/wireless/ath5k/phy.c b/drivers/net/wireless/ath5k/phy.c
index 69625bf4d11c..7ba18e09463b 100644
--- a/drivers/net/wireless/ath5k/phy.c
+++ b/drivers/net/wireless/ath5k/phy.c
@@ -2196,9 +2196,7 @@ static int ath5k_hw_rf5110_calibrate(struct ath5k_hw *ah,
 		return ret;
 	}
 
-	ret = ath5k_hw_noise_floor_calibration(ah, channel->center_freq);
-	if (ret)
-		return ret;
+	ath5k_hw_noise_floor_calibration(ah, channel->center_freq);
 
 	/*
 	 * Re-enable RX/TX and beacons
diff --git a/drivers/net/wireless/ath5k/reset.c b/drivers/net/wireless/ath5k/reset.c
index b51bc030da02..5003263c9ea4 100644
--- a/drivers/net/wireless/ath5k/reset.c
+++ b/drivers/net/wireless/ath5k/reset.c
@@ -842,9 +842,7 @@ int ath5k_hw_reset(struct ath5k_hw *ah, enum nl80211_iftype op_mode,
 	 *
 	 * XXX: Find an interval that's OK for all cards...
 	 */
-	ret = ath5k_hw_noise_floor_calibration(ah, channel->center_freq);
-	if (ret)
-		return ret;
+	ath5k_hw_noise_floor_calibration(ah, channel->center_freq);
 
 	/*
 	 * Reset queues and start beacon timers at the end of the reset routine
-- 
GitLab