scsi: smartpqi: Stop logging spurious PQI reset failures

Change method used to detect controller firmware crash during PQI reset.

PQI reset can fail with error -6 if firmware takes > 100ms to complete
reset.

Method used by driver to detect controller firmware crash during PQI was
incorrect in some cases.

Link: https://lore.kernel.org/r/165730605108.177165.1132931838384767071.stgit@brunhildaReviewed-by: NScott Benesh <scott.benesh@microchip.com>
Reviewed-by: NScott Teel <scott.teel@microchip.com>
Reviewed-by: NMike McGowen <mike.mcgowen@microchip.com>
Signed-off-by: NKevin Barnett <kevin.barnett@microchip.com>
Signed-off-by: NDon Brace <don.brace@microchip.com>
Signed-off-by: NMartin K. Petersen <martin.petersen@oracle.com>

drivers/scsi/smartpqi/smartpqi_init.c

@@ -7412,8 +7412,7 @@ static int pqi_wait_for_pqi_reset_completion(struct pqi_ctrl_info *ctrl_info)
 		reset_reg.all_bits = readl(&pqi_registers->device_reset);
 		if (reset_reg.bits.reset_action == PQI_RESET_ACTION_COMPLETED)
 			break;
-		pqi_check_ctrl_health(ctrl_info);
-		if (pqi_ctrl_offline(ctrl_info)) {
+		if (!sis_is_firmware_running(ctrl_info)) {
 			rc = -ENXIO;
 			break;
 		}