ARM: mini2440: Move to using gpiolib API and s3c_gpio functions

Move the mach-mini2440 to using the gpiolib API for GPIOS it
directly uses, and s3c_gpio calls for configuration.
Signed-off-by: NBen Dooks <ben-linux@fluff.org>

arch/arm/mach-s3c2440/mach-mini2440.c

@@ -103,10 +103,10 @@ static void mini2440_udc_pullup(enum s3c2410_udc_cmd_e cmd)
 
 	switch (cmd) {
 		case S3C2410_UDC_P_ENABLE :
-			s3c2410_gpio_setpin(S3C2410_GPC(5), 1);
+			gpio_set_value(S3C2410_GPC(5), 1);
 			break;
 		case S3C2410_UDC_P_DISABLE :
-			s3c2410_gpio_setpin(S3C2410_GPC(5), 0);
+			gpio_set_value(S3C2410_GPC(5), 0);
 			break;
 		case S3C2410_UDC_P_RESET :
 			break;
@@ -636,22 +636,22 @@ static void __init mini2440_init(void)
 	s3c_gpio_cfgpin(S3C2410_GPC(0), S3C2410_GPC0_LEND);
 
 	/* Turn the backlight early on */
-	s3c2410_gpio_setpin(S3C2410_GPG(4), 1);
-	s3c_gpio_cfgpin(S3C2410_GPG(4), S3C2410_GPIO_OUTPUT);
+	WARN_ON(gpio_request(S3C2410_GPG(4), "backlight"));
+	gpio_direction_output(S3C2410_GPG(4), 1);
 
 	/* remove pullup on optional PWM backlight -- unused on 3.5 and 7"s */
-	s3c2410_gpio_pullup(S3C2410_GPB(1), 0);
+	s3c_gpio_setpull(S3C2410_GPB(1), S3C_GPIO_PULL_UP);
 	s3c2410_gpio_setpin(S3C2410_GPB(1), 0);
 	s3c_gpio_cfgpin(S3C2410_GPB(1), S3C2410_GPIO_INPUT);
 
 	/* Make sure the D+ pullup pin is output */
-	s3c_gpio_cfgpin(S3C2410_GPC(5), S3C2410_GPIO_OUTPUT);
+	WARN_ON(gpio_request(S3C2410_GPC(5), "udc pup"));
+	gpio_direction_output(S3C2410_GPC(5), 0);
 
 	/* mark the key as input, without pullups (there is one on the board) */
 	for (i = 0; i < ARRAY_SIZE(mini2440_buttons); i++) {
-		s3c2410_gpio_pullup(mini2440_buttons[i].gpio, 0);
-		s3c_gpio_cfgpin(mini2440_buttons[i].gpio,
-					S3C2410_GPIO_INPUT);
+		s3c_gpio_setpull(mini2440_buttons[i].gpio, S3C_GPIO_PULL_UP);
+		s3c_gpio_cfgpin(mini2440_buttons[i].gpio, S3C2410_GPIO_INPUT);
 	}
 	if (features.lcd_index != -1) {
 		int li;