x86, topology: Don't offline CPU0 if any PIC irq can not be migrated out of it

If CONFIG_BOOTPARAM_HOTPLUG_CPU is turned on, CPU0 hotplug feature is enabled
by default.

If CONFIG_BOOTPARAM_HOTPLUG_CPU is not turned on, CPU0 hotplug feature is not
enabled by default. The kernel parameter cpu0_hotplug can enable CPU0 hotplug
feature at boot.

Currently the feature is supported on Intel platforms only.
Signed-off-by: NFenghua Yu <fenghua.yu@intel.com>
Link: http://lkml.kernel.org/r/1352835171-3958-4-git-send-email-fenghua.yu@intel.comSigned-off-by: NH. Peter Anvin <hpa@linux.intel.com>

arch/x86/kernel/topology.c

@@ -30,23 +30,59 @@
 #include <linux/mmzone.h>
 #include <linux/init.h>
 #include <linux/smp.h>
+#include <linux/irq.h>
 #include <asm/cpu.h>
 
 static DEFINE_PER_CPU(struct x86_cpu, cpu_devices);
 
 #ifdef CONFIG_HOTPLUG_CPU
+
+#ifdef CONFIG_BOOTPARAM_HOTPLUG_CPU0
+static int cpu0_hotpluggable = 1;
+#else
+static int cpu0_hotpluggable;
+static int __init enable_cpu0_hotplug(char *str)
+{
+	cpu0_hotpluggable = 1;
+	return 1;
+}
+
+__setup("cpu0_hotplug", enable_cpu0_hotplug);
+#endif
+
 int __ref arch_register_cpu(int num)
 {
+	struct cpuinfo_x86 *c = &cpu_data(num);
+
+	/*
+	 * Currently CPU0 is only hotpluggable on Intel platforms. Other
+	 * vendors can add hotplug support later.
+	 */
+	if (c->x86_vendor != X86_VENDOR_INTEL)
+		cpu0_hotpluggable = 0;
+
 	/*
-	 * CPU0 cannot be offlined due to several
-	 * restrictions and assumptions in kernel. This basically
-	 * doesn't add a control file, one cannot attempt to offline
-	 * BSP.
+	 * Two known BSP/CPU0 dependencies: Resume from suspend/hibernate
+	 * depends on BSP. PIC interrupts depend on BSP.
 	 *
-	 * Also certain PCI quirks require not to enable hotplug control
-	 * for all CPU's.
+	 * If the BSP depencies are under control, one can tell kernel to
+	 * enable BSP hotplug. This basically adds a control file and
+	 * one can attempt to offline BSP.
+	 */
+	if (num == 0 && cpu0_hotpluggable) {
+		unsigned int irq;
+		/*
+		 * We won't take down the boot processor on i386 if some
+		 * interrupts only are able to be serviced by the BSP in PIC.
 		 */
-	if (num)
+		for_each_active_irq(irq) {
+			if (!IO_APIC_IRQ(irq) && irq_has_action(irq)) {
+				cpu0_hotpluggable = 0;
+				break;
+			}
+		}
+	}
+	if (num || cpu0_hotpluggable)
 		per_cpu(cpu_devices, num).cpu.hotpluggable = 1;
 
 	return register_cpu(&per_cpu(cpu_devices, num).cpu, num);