usb: musb: enable ux500 host side dma support

Host side dma support for ux500 is enabled by piggybacking on Inventra
dma support.
Acked-by: NLinus Walleij <linus.walleij@linaro.org>
Signed-off-by: NMian Yousaf Kaukab <mian.yousaf.kaukab@stericsson.com>
Signed-off-by: NFabio Baltieri <fabio.baltieri@linaro.org>
Signed-off-by: NFelipe Balbi <balbi@ti.com>

drivers/usb/musb/musb_host.c

@@ -629,7 +629,7 @@ static bool musb_tx_dma_program(struct dma_controller *dma,
 	u16			csr;
 	u8			mode;
 
-#ifdef	CONFIG_USB_INVENTRA_DMA
+#if defined(CONFIG_USB_INVENTRA_DMA) || defined(CONFIG_USB_UX500_DMA)
 	if (length > channel->max_len)
 		length = channel->max_len;
 
@@ -1663,7 +1663,7 @@ void musb_host_rx(struct musb *musb, u8 epnum)
 
 	/* FIXME this is _way_ too much in-line logic for Mentor DMA */
 
-#ifndef CONFIG_USB_INVENTRA_DMA
+#if !defined(CONFIG_USB_INVENTRA_DMA) && !defined(CONFIG_USB_UX500_DMA)
 	if (rx_csr & MUSB_RXCSR_H_REQPKT)  {
 		/* REVISIT this happened for a while on some short reads...
 		 * the cleanup still needs investigation... looks bad...
@@ -1695,7 +1695,7 @@ void musb_host_rx(struct musb *musb, u8 epnum)
 			| MUSB_RXCSR_RXPKTRDY);
 		musb_writew(hw_ep->regs, MUSB_RXCSR, val);
 
-#ifdef CONFIG_USB_INVENTRA_DMA
+#if defined(CONFIG_USB_INVENTRA_DMA) || defined(CONFIG_USB_UX500_DMA)
 		if (usb_pipeisoc(pipe)) {
 			struct usb_iso_packet_descriptor *d;
 
@@ -1751,7 +1751,7 @@ void musb_host_rx(struct musb *musb, u8 epnum)
 		}
 
 		/* we are expecting IN packets */
-#ifdef CONFIG_USB_INVENTRA_DMA
+#if defined(CONFIG_USB_INVENTRA_DMA) || defined(CONFIG_USB_UX500_DMA)
 		if (dma) {
 			struct dma_controller	*c;
 			u16			rx_count;